Results 71 to 80 of about 378,947 (242)
A compact resistively loaded metamaterial absorber captures RF energy at 2.4 GHz and directs most of the accepted power to modeled loads. The resonant response is confirmed experimentally for the fabricated absorber, while an impedance‐matched rectifier is evaluated through simulation. The stage‐wise results distinguish absorber, rectifier, and cascade
Md. Murad Kabir Nipun, Md. Jahedul Islam
wiley +1 more source
The effect of standing waves on the attenuation constant for a low‐loss rectangular waveguide
When standing waves are present in a rectangular waveguide, the resistive losses in the walls are not uniformly distributed. This affects the measurement of the attenuation constant.
Richard J. Collier +2 more
doaj +1 more source
AFully Micromachined W-Band Coplanar Waveguide to Rectangular Waveguide Transition
- A novel fully micromachined coplanar waveguide (CPW) to rectangular waveguide transition is presented in this paper.A metalized probe is adopted to couple the signal from the CPW to the rectangular waveguide through an aperture located at the center of
Bo Pan +4 more
core +1 more source
Self‐Sensing Artificial‐Muscle‐Empowered Humanlike Perception, Interaction, and Positioning
The proposed self‐sensorized artificial muscle (SSAM) can sense its length change as small as 0.01 mm via a seamlessly integrated multi‐segment induction coil. The SSAM provides accurate length information regardless of its loadings, driving pressure, or muscle design, adequate for robust data‐driven feedback control.
Houping Wu +6 more
wiley +1 more source
A new rectangular waveguide to coplanar waveguide transition [PDF]
A new rectangular waveguide to coplanar waveguide (CPW) transition is described. The transition uses a ridge in one of the broad walls of the waveguide and a nonradiating slot in the opposite wall to split and rotate the electromagnetic fields of the ...
Ponchak, George E., Simons, Rainee N.
core
We computationally investigate the mechanical, electronic, and optical properties of strained GeSn microdisks on silicon substrates. By combining photo‐elasticity, strain‐dependent band‐structure calculations, and optical mode analysis, we study how strain distribution, structural configuration, and temperature affect the electronic band structure and ...
Jon Schlipf +5 more
wiley +1 more source
High-efficiency transition between rectangular waveguide and domino plasmonic waveguide
In this work, we propose an optimized transition structure to realize smooth and high efficiency conversion from the guided wave supported by a conventional rectangular waveguide (CRW) to the domino plasmon polaritons (DPPs) supported by a domino ...
Liangliang Liu +7 more
doaj +1 more source
Left handed rectangular waveguide resonator structures
SRRs are constructed as two square-shaped rings, each interrupted by a small gap, as shown in Fig. 1. Embedding small single split resonator elements on a dielectric substrate we obtain negative magnetic permeability for a metamaterials-based ...
Budimir, D., Shelkovnikov, A.B.
core
Novel SRR loaded waveguide bandstop filters [PDF]
Two types of novel split ring resonator (SRR) loaded rectangular waveguide bandstop filter structures have been presented. The first proposed SRR-loaded waveguide bandstop filter has been designed simulated and tested.
Budimir, D. +5 more
core +1 more source
A Non‐Volatile Heterogeneous Quantum Dot III‐V/Si DFB Laser With Optical Memristive Behavior
A heterogeneous quantum dot III‐V/Si DFB laser stores its own optical state. An ultrathin Al2O3 memristor at the III‐V/Si interface produces non‐volatile wavelength shifts of ∼46 pm and ∼17 dB peak power contrast with zero holding power. Combining coherent light generation and persistent memory in one device opens a path toward neuromorphic photonics ...
Stanley Cheung +7 more
wiley +1 more source

