Results 111 to 120 of about 707,343 (311)
DEVELOPMENT DRIVERS OF WASTE RECYCLING IN NSUKKA URBAN AREA, SOUTHEASTERN NIGERIA [PDF]
This article examines drivers of waste recovery and recycling in the informal waste sector in Nsukka urban area of Enugu State, southeastern Nigeria. Data on socioeconomic and demographic characteristics of waste pickers and waste dealers in the area ...
Thaddeus Chidi NZEADIBE
core
Advanced Engineering Materials, EarlyView.Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source
The Potential of Deconstruction in Buffalo, New York [PDF]
, 2007 Building deconstruction is not a novel idea but represents an ancient practice reinvented for our modern era. Deconstruction is an environmentally friendly (yet fiscally remunerative) alternative to traditional building demolition.
Faleski, Erik
core +1 more source
Application of Raman and Photoluminescence Spectroscopy to MgO‐C Refractories
Advanced Engineering Materials, EarlyView.Visible to near infrared luminescence of MgO is studied on MgO‐C bricks and nominally pure MgO powder, with focus on two similar sharp high‐intensity signals, at 699 and 871 nm, each surrounded by symmetrical sidebands. The nature of these sidebands is investigated by temperature‐dependent spectroscopic measurements, confirming phonon involvement by ...
Julia Richter +5 more
wiley +1 more source
Recycling of phosphorus and ammonia nitrogen from digestate [PDF]
, 2018 Digestate from biogas plants, formed by dewatering anaerobically stabilized sludge, is characteristic of high concentrations of phosphates and ammonia nitrogen suitable for further use.
Calábková, Katrin +3 more
core
Mechanical characterization of ABS recyling based electric and electronic equipment (WEEE) by using injection molding [PDF]
, 2020 Nowadays, recycling process become more and more importantly mostly due to the impressive increase in the production of waste and to growing attention to the environment friendly.
M. Rus, Anika Zafiah +8 more
core
Advanced Engineering Materials, EarlyView.The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Applications of Plasma Technologies in Recycling Processes
MaterialsPlasmas are reactive ionised gases, which enable the creation of unique reaction fields. This allows plasmas to be widely used for a variety of chemical processes for materials, recycling among others. Because of the increase in urgency to find more sustainable methods of waste management, plasmas have been enthusiastically applied to recycling ...
Reinosuke Kusano, Yukihiro Kusano
openaire +3 more sources
Advanced Engineering Materials, EarlyView.ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir +7 more
wiley +1 more source