Results 161 to 170 of about 1,642,747 (316)

Investigating the Low‐Temperature Phase Stability of the Binary Ta–W System

open access: yesAdvanced Engineering Materials, EarlyView.
Atomistic simulations show that the binary Ta–W system forms ordered intermetallic phases, B2‐TaW and D03‐TaW3, as 0 K ground states. Configurational entropy, however, lowers the free energy of the disordered bcc solid solution, which becomes the stable phase above about 400 K.
Klemens Lechner   +7 more
wiley   +1 more source

Lusaka October 2010 Basic Needs and Nutrition Basket Report

open access: yes, 2010
This survey was conducted on 27 & 28 October 2010 by the Social Conditions Programme of the Jesuit Centre for Theological Reflection. Average prices were calculated on the basis of prices gathered from retail outlets at Northmead, Shoprite (Kafue Road ...
Jesuit Centre for Theological Reflection
core  

Impact of the Process Atmosphere During Hot Isostatic Pressing on the Near‐Surface Composition of an Additively Manufactured Austenitic High‐Interstitial Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A high interstital austenitic steel is additively manufactured and postdensified by HIP to eliminate gas porosity. Thereby, the loss of N and Mn in Ar HIP atmosphere is investigated. Further, HIP using N2 atmosphere is investigated which led to excessive nitride formation.
F. Großwendt   +4 more
wiley   +1 more source

Using a Programme-Level Approach to Developing Reflective Practice in Health Professions Education in the Age of AI. [PDF]

open access: yesClin Teach
Sapsed C   +11 more
europepmc   +1 more source

Lusaka April 2013 Basic Needs and Nutrition Basket Report

open access: yes, 2013
This survey was conducted on 29th April, 2013 by the Social Conditions Programme of the Jesuit Centre for Theological Reflection. Average prices were calculated on the basis of prices gathered from retail outlets at Northmead, Shoprite (Cairo Road), City
Jesuit Centre for Theological Reflection
core  

Microstructure‑Dependent Phase Transformations Under High‑Pressure Laser Heating in Additively Manufactured AlCrFe2Ni2

open access: yesAdvanced Engineering Materials, EarlyView.
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika   +5 more
wiley   +1 more source

Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel

open access: yesAdvanced Engineering Materials, EarlyView.
Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe   +9 more
wiley   +1 more source

Home - About - Disclaimer - Privacy