Results 71 to 80 of about 601,437 (304)
Advanced Engineering Materials, EarlyView.Additive manufacturing provides precise control over the placement of continuous fibres within polymer matrices, enabling customised mechanical performance in composite components. This article explores processing strategies, mechanical testing, and modelling approaches for additive manufactured continuous fibre‐reinforced composites.
Cherian Thomas, Amir Hosein Sakhaei
wiley +1 more source
Phase of the seabed frequency-domain reflection coefficient: Measurements and modelinga) [PDF]
JASA Express LettersThe phase of the seabed frequency-domain reflection coefficient potentially contains valuable information on the geoacoustic properties in a layered/refracting seabed. However, heretofore, the phase has not been exploited.
Charles W. Holland
doaj +1 more source
Phase Field Failure Modeling: Brittle‐Ductile Dual‐Phase Microstructures under Compressive Loading
Advanced Engineering Materials, EarlyView.The approach by Amor and the approach by Miehe and Zhang for asymmetric damage behavior in the phase field method for fracture are compared regarding their fitness for microcrack‐based failure modeling. The comparison is performed for the case of a dual‐phase microstructure with a brittle and a ductile constituent.
Jakob Huber, Jan Torgersen, Ewald Werner
wiley +1 more source
Membrane Reflection Coefficient
, 1981 Department of Chemistry, Bhagalpur University, Bhagalpur-812 007 Manuscript received 25 February 1980, revised 16 September 1980, accepted 10 March 1981 Membrane Reflection ...
S. N. JHA, S. P. JHA, Md. ZAKARIA
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source
A microwave dielectric biosensor based on suspended distributed MEMS transmission lines [PDF]
, 2009 Design and characterization of a miniature microwave dielectric biosensor based on distributed microelectromechanical systems (MEMS) transmission lines (DMTL) is reported in this paper.
Li, Lijie +3 more
core +1 more source
An Experimental High‐Throughput Approach for the Screening of Hard Magnet Materials
Advanced Engineering Materials, EarlyView.An entire workflow for the high‐throughput characterization and analysis of compositionally graded magnetic films is presented. Characterization protocols, data management tools and data analysis approaches are illustrated with test case Sm(Fe, V)12 based films.
William Rigaut +16 more
wiley +1 more source
Simple Technique for source reflection coefficient measurement while characterizing active devices [PDF]
, 1999 This paper describes a simple, yet rigorous technique for fast and accurate determination of the source reflection coefficient during the characterization of microwave active devices.
Ferrero, ANDREA PIERENRICO +1 more
core +1 more source
Advanced Engineering Materials, EarlyView.Aluminum and nitride coatings are used in industry because they are hard, resist wear, and protect against oxidation. Adding boron can improve friction behavior and other properties. This study tests coatings on surfaces with different finishes. Results show smoother surfaces perform better, while rough ones wear faster, although coatings can reduce ...
Adrián Claver +9 more
wiley +1 more source
Dielectric Properties Determination of a Stratified Medium [PDF]
Radioengineering, 2015 The method of detection of variation in dielectric properties of a material covered with another material, which requires nondestructive measurement, has numerous applications and the accurate measurement system is desirable.
P. Yoiyod, M. Krairiksh
doaj