Results 51 to 60 of about 2,185,201 (309)

Modelling and Analysis of Vector and Vector Vortex Beams Reflection for Optical Sensing

open access: yesPhotonics
Light Detection and Ranging (LiDAR) sensors can precisely determine object distances using the pulsed time of flight (TOF) or amplitude-modulated continuous wave (AMCW) TOF methods and velocity using the frequency-modulated continuous wave (FMCW ...
Wangke Yu, Jize Yan
doaj   +1 more source

Impact of the Process Atmosphere During Hot Isostatic Pressing on the Near‐Surface Composition of an Additively Manufactured Austenitic High‐Interstitial Steel

open access: yesAdvanced Engineering Materials, EarlyView.
A high interstital austenitic steel is additively manufactured and postdensified by HIP to eliminate gas porosity. Thereby, the loss of N and Mn in Ar HIP atmosphere is investigated. Further, HIP using N2 atmosphere is investigated which led to excessive nitride formation.
F. Großwendt   +4 more
wiley   +1 more source

Optical properties of ternary alloys MgZnO in infrared spectrum

open access: yesSemiconductor Physics, Quantum Electronics & Optoelectronics, 2018
Properties of thin films of ternary alloys Mg х Zn 1–х O on the optically-anisotropic Al 2 O 3 substrates in the area of “residual rays” of film and substrate are first investigated using the method of infrared spectroscopy and dispersion analysis of ...
E.F. Venger   +5 more
doaj   +1 more source

Microstructure‑Dependent Phase Transformations Under High‑Pressure Laser Heating in Additively Manufactured AlCrFe2Ni2

open access: yesAdvanced Engineering Materials, EarlyView.
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika   +5 more
wiley   +1 more source

Vectorial characterization of surface wave via one-dimensional photonic-atomic structure

open access: yesScientific Reports, 2023
Quantitative assessment of polarization properties of waves opens up the way for effective exploitation of them in many amazing applications. Tamm surface waves (TSW) that propagate on the interface of periodic dielectric media are proposed for many ...
M. Asadolah Salmanpour   +2 more
doaj   +1 more source

Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel

open access: yesAdvanced Engineering Materials, EarlyView.
Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe   +9 more
wiley   +1 more source

Adjusting Nucleation Chemistry for the Atomic Layer Deposition of Antimony Selenide on Metal Oxide Surfaces

open access: yesAdvanced Engineering Materials, EarlyView.
The ALD precursor bis(trimethylsilyl)selenide is simultaneously a substrate surface inhibitor. It allows for the growth of Sb2Se3 in combination with tris(dimethylamido)antimony, but also silylates surface hydroxyl groups on the substrate if such hydroxyls are present.
Pei‐Chun Liao   +9 more
wiley   +1 more source

Effect of Calendering and Surface Treatment on the Thermochromic Response of Cholesteric Liquid Crystals on PET Nonwovens

open access: yesAdvanced Engineering Materials, EarlyView.
This study explores the influences of calendering and surface treatment during direct ink writing (DIW) of thermochromic cholesteric liquid crystal (CLC) on PET nonwovens. For the PVA‐coated nonwovens, calendering reduces pore size leading to reduced ink absorption and enhanced spreading. The NeverWet‐coated nonwovens improve thermochromic responses by
Sreenivasan Sreenivasan Narayanan   +3 more
wiley   +1 more source

November 2012 Case Study: Acrive Citizenship Beyond Elections

open access: yes, 2012
Human rights are the only universally recognized system of values under present international law. This system provides a network of minimum standards and procedural rules for human relations, all of which are equally applicable not only to governments ...
Jesuit Centre for Theological Reflection
core  

Wearable Smart Patches on Sustainable Chitosan With Reversible Microbial Growth‐Inhibitory Properties

open access: yesAdvanced Functional Materials, EarlyView.
ABSTRACT Chitosan, a polysaccharide upcycled from biowaste, has long promised sustainable, biocompatible, and antimicrobial films and devices, an appeal reinforced by its recent regulatory recognition, with several chitosan‐based antibacterial dressings gaining clearance through the Food and Drug Administration's 510(k) pathway.
Jacopo Nicoletti   +16 more
wiley   +1 more source

Home - About - Disclaimer - Privacy