Results 31 to 40 of about 1,932,036 (272)
The VIIRS instrument on the JPSS-2 (renamed NOAA-21 upon reaching orbit) spacecraft was launched in November 2022, making it the third sensor in the VIIRS series, following those onboard the SNPP and NOAA-20 spacecrafts, which are operating nominally. As
Aisheng Wu +5 more
doaj +1 more source
The visible infrared imaging radiometer suite (VIIRS) onboard the National Oceanic and Atmospheric Administration - 20 (NOAA-20) satellite was successfully launched in November 2017.
Wenhui Wang, Changyong Cao
doaj +1 more source
Deep convective clouds (DCC) are identified by using a combination of brightness temperature (BT) and visible reflectance thresholds. Moreover, it is common practice to use daytime DCC measurements for the calibration assessment of reflective solar and ...
Tiejun Chang +3 more
doaj +1 more source
An Overall Assessment of JPSS-2 VIIRS Radiometric Performance Based on Pre-Launch Testing
The Visible Infrared Imaging Radiometer Suite (VIIRS) on-board the second Joint Polar Satellite System (JPSS) completed its sensor level testing in February 2018.
Hassan Oudrari +6 more
doaj +1 more source
The East-West Response Versus Scan-Angle Performance of GOES-16/17 ABI Solar Reflective Bands [PDF]
The scan mirror reflectivity of the Advanced Baseline Imager (ABI) solar reflective bands was characterized before launch to ensure calibration uniformity. To verify, a series of lunar images were collected during the GOES-16/17 ABI post-launch test/post-
Qian, Haifeng +3 more
core +1 more source
This study advances SafeWax, a bio‐inspired, fatty‐acids‐based superhydrophobic coating, by identifying an agriculturally compliant solvent and revealing how solvent‐controlled Fatty acid crystallization governs the coating's microscopic structure and performance.
Niv Ben‐Arie +13 more
wiley +1 more source
Anti-Reflective Zeolite Coating for Implantable Bioelectronic Devices
Since sunlight is one of the most easily available and clean energy supplies, solar cell development and the improvement of its conversion efficiency represent a highly interesting topic. Superficial light reflection is one of the limiting factors of the
Giuseppe Oliva +3 more
doaj +1 more source
Electronic and structural characterisation of Cu3BiS3 thin films for the absorber layer of sustainable photovoltaics [PDF]
Thin films of p-type Cu3BiS3 with an orthorhombic wittichenite structure, a semiconductor with high potential for thin film solar cell absorber layers, were synthesised by thermal annealing of Cu and Bi precursors, magnetron sputtered on Mo/glass ...
Maiello, P. +8 more
core +4 more sources
An Adaptive Inhibitory WSe2 Transistor for Retinomorphic In‐Sensor Image Processing
Conventional retinomorphic devices typically require deliberate gate‐bias tuning for each illumination condition. In this paper, we demonstrate an adaptive inhibitory WSe2 transistor that uses photo‐induced regime shift between the subthreshold and accumulation modes to achieve decision‐free, intensity‐adaptive image processing within a single pixel ...
Juhwan Baek +12 more
wiley +1 more source
Solution‐based ligand‐assisted epitaxial growth (LAEG) yields high‐quality CsPbBr3 microcrystals on different substrates with superior morphology, passivated surfaces, and high photoluminescence quantum yield. These robust micro‐resonators achieve record‐low room‐temperature lasing thresholds of 7.2 kW·cm−2 and maintain operational stability up to 90 ...
Shuyu Zhou +19 more
wiley +1 more source

