Results 1 to 10 of about 9,836 (120)
MICROSTRUCTURE AND INTERFACIAL INTERMETALLIC OF Sn-3.0Ag-0.5Cu/Sn-58Bi SOLDER JOINT FOR PACKAGE-ON-PACKAGE TECHNOLOGY [PDF]
In this study, the effect of growth microstructure on diffusion and intermetallic compound of Sn-58Bi/SAC305 solder joint with different of SAC305 size and reflow temperature had been studied.
Mohd Izrul Izwan RAMLI +4 more
doaj +1 more source
Background: The release of lipid-laden plaque material subsequent to ST-segment elevation myocardial infarction (STEMI) may contribute to the no-reflow phenomenon.
Yosuke Katayama +8 more
doaj +1 more source
Influence of Substrate on Microvia Structures in Printed Circuit Boards During Reflow
The automotive industry’s increasing dependence on compact electronic packages requires printed circuit boards with robust microvia interconnections.
Syed Mujahid Abbas +2 more
doaj +1 more source
Forming Coatings from Self-Fluxing Powder Based on Steels of Austenite Class Adding Molybdenum
The paper presents a study of the effect of adding Mo and MoS2 on the microstructure and properties of a powder coating based on austenitic steels.
F. I. Panteleenko +5 more
doaj +1 more source
Platelet-To-Lymphocyte Ratio as a Predictor of No-Reflow after Primary Percutaneous Coronary Intervention in Patients with ST Elevation Myocardial Infarction: A Systematic Review and Meta-Analysis [PDF]
Introduction: No-reflow increases the complications and mortality rate of primary percutaneous coronary intervention (PCI). Therefore, it is important to identify patients at a higher risk of developing no-reflow.
Amin Saberi +3 more
doaj +1 more source
Aim: The aim of this study was to investigate the relationship between no-reflow (no-RF), reflow (RF), and the P-wave time index in patients undergoing percutaneous coronary intervention (PCI) with a diagnosis of acute myocardial infarction (AMI) due to ...
Ahmet Karakurt +2 more
doaj +1 more source
Objective: No-reflow phenomenon is one of well-known complications of percutaneous coronary intervention (PCI). The rate of no-reflow phenomenon was reported between 2-44% differing on the accompanying situations and more frequent in acute myocardial ...
Esra Dönmez +3 more
doaj +1 more source
The Effect Of Void Formation On The Reliability Of ED-XRF Measurements In Lead-Free Reflow Soldering
In lead-free reflow soldering, the presence of voids should be taken into account. For this reason, the effect of the applied heating profiles was examined via the characterization of voids in galvanic and immersion Sn coatings. According to EU Directive
Koncz-Horváth D., Gergely G., Gácsi Z.
doaj +1 more source
Although percutaneous coronary intervention (PCI) significantly improves the prognosis for myocardial infarction, the no-reflow phenomenon is still the major adverse complication of PCI leading to increased mortality, especially for the patients with ST ...
Fang Liu +5 more
doaj +1 more source
An Analysis of Starved EHL Point Contacts with Reflow
In the starved lubrication regime, the film thickness can be much less than the fully flooded film thickness. The film thickness reduction is related to the inlet meniscus distance.
Takashi Nogi
doaj +1 more source

