Results 231 to 240 of about 1,353,644 (282)

Structural response of RC beam-column joints reinforced with smart alloys and polyvinyl alcohol fibers. [PDF]

Sci Rep
Alqarni AS, Alshannag MJ, Higazey MM.
europepmc   +1 more source

Corrosion-Induced Crack Quantification in Reinforced Concrete with Portland and Slag-Blended Cement Under Accelerated Exposure. [PDF]

Materials (Basel)
Krauze B, Ribakov Y, Lifshitz Sherzer G.
europepmc   +1 more source

Seismic performance assessment and strengthening of a residential RC building damaged in the 2023 Türkiye Earthquakes: A case study. [PDF]

Sci Rep
Peker FÜ, Yuzbasi J, Işık E, Avcil F, Büyüksaraç A.   +4 more
europepmc   +1 more source

Influence of microwave excitation mode and antenna-sample orientation on rebar detection using microwave infrared thermography. [PDF]

Sci Rep
Szymanik B, Keo SA, Brachelet F, Defer D.   +3 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Flexural behaviour of RC beams in fibre reinforced concrete

Composites Part B: Engineering, 2012
Abstract Even though a number of research studies have demonstrated the effectiveness of Fibre Reinforced Concrete (FRC) in improving the structural response of RC members under different loading conditions, some concerns recently arose on the sectional ductility under flexure which can be reduced under specific conditions.
MEDA, Alberto, MINELLI, Fausto, PLIZZARI, Giovanni   +2 more
openaire   +3 more sources

Investigations on textile-reinforced concrete as cover for RC beams

Magazine of Concrete Research, 2016
The present paper reports investigations carried out on textile-reinforced concrete (TRC) as a tension zone cover for reinforced concrete beams towards attaining improved serviceability and durability. TRC consists of a cementitious binder and an alkali-resistant glass fabric.
Smitha Gopinath, Avadhanam Ramachandra Murthy, Nagesh R. Iyer, Ramamoorthy Dharinee   +3 more
openaire   +1 more source

Reliability Analysis of Reinforced Concrete (RC) Plates and Shells

Volume 11: Transportation Systems, 2012
The application of the principles of probabilistic techniques to structural design has been gaining widespread acceptance over the last two decades. However, the design of many engineering structures is still based on standard deterministic design codes that may not account for inherent design and material variability.
Pattabhi Sitaram, Sudhir Kaul
openaire   +1 more source

Modelling of RC Beams Strengthened with Basalt Reinforced Concrete

Journal of The Institution of Engineers (India): Series A, 2017
An analytical model was developed to predict the response behaviour of RC beam strengthened with basalt reinforced concrete. The model was based on the internal forces, strains, and stresses in the cross- section of the strengthened composite beam. It is observed that the analytical results are in good agreement with experimental results.
Smitha Gopinath, M. Prabha, A. Ramachandra Murthy, Nagesh R. Iyer   +3 more
openaire   +1 more source

Strengthening and repair of RC beams with fiber reinforced concrete

Cement and Concrete Composites, 2010
The use of a jacket made of fiber reinforced concrete with tensile hardening behavior for strengthening RC beams is investigated by means of full-scale tests on 4.55 m long beams. A 40 mm jacket of this material was directly applied to the beam surface. Both the strengthening and the repair of RC beams were studied.
Martinola, G, MEDA, ALBERTO, Plizzari, GA, RINALDI, ZILA   +3 more
openaire   +4 more sources

Strengthening of RC slabs with reinforced concrete overlay on the tensile face

Engineering Structures, 2017
Abstract Strengthening of concrete structures with a new concrete layer has been commonly used for columns, beams and slabs. This technique is economic and efficient for structural strengthening since it uses the same base materials, steel and concrete.
Hugo Fernandes, Válter Lúcio, António Ramos   +2 more
openaire   +1 more source