Results 91 to 100 of about 1,606 (256)
FlexMat, EarlyView.Abstract Soft robots, engineered from highly compliant materials, offer superior adaptability and safety in unstructured environments compared to their rigid counterparts. Recent advancements, fueled by bio‐inspiration and material programmability, have led to the rapid co‐evolution of their core modules: actuation, sensing, protection, energy, and ...
Qiulei Liu +3 more
wiley +1 more source
Materials and Corrosion, EarlyView.The hardness and corrosion resistance of the martensitic stainless steel X30Cr13 depend directly on the applied heat treatment. This article describes and discusses the relationships between alloy composition, thermodynamic phase stabilities, heat treatment parameters, resulting microstructures, and achievable corrosion resistance. To investigate these
Adrian Evia Ocampo +3 more
wiley +1 more source
Materials and Corrosion, EarlyView.Schematic depicting corrosion layer formation and changes in stainless steel exposed to Solar Salt at 600°C for 1000 h under different atmospheres: (a) N2 accelerates salt decomposition, producing nitrite and oxide ions, causing severe corrosion. (b) Adding O2 reduces nitrite ions formation, resulting in less corrosion than N2 alone.
Sumit Kumar +4 more
wiley +1 more source
Metals, 2018 Results of dynamic tensile testing of three-step low-temperature-transformed nanostructured bainitic steel and quenching and partitioning martensitic steel at different strain rates (0.1⁻500 s−1) are reported here. The results showed that the
Wen Zhou +4 more
doaj +1 more source
Materials and Corrosion, EarlyView.The localized corrosion behavior of lean duplex stainless steel EN 1.4062 is systematically compared with austenitic and higher‐alloyed duplex grades in natural seawater. A clear resistance ranking is established, highlighting EN 1.4062 as a cost‐effective alternative for limited marine exposure.
Mohammad Hassanzadeh +4 more
wiley +1 more source
工程科学学报, 2019 Hot deformation is a way to effectively improve strength and plasticity of multiphase steels simultaneously, thereby, improving mechanical properties of multiphase steels.
TIAN Ya-qiang +6 more
doaj +1 more source
Materials and Corrosion, EarlyView.This article examines the impact of externally introduced chromium compounds on the localized corrosion of 316 L stainless steel in acidic chloride environments such as hydrochloric acid. While the corrosion resistance of 316 L relies on the formation of a chromium‐rich passive oxide layer, industrial conditions may expose the steel to various chromium
Florence Lequien
wiley +1 more source
Materialwissenschaft und Werkstofftechnik, EarlyView.This research provides an extensive and sophisticated analysis of debris produced by micro‐electrical discharge machining processing of Ni‐Ti shape memory alloys and austenitic stainless steel (SS304) using brass electrodes. The research examines how different discharge energy levels controlled by capacitance and voltage affect debris shape and ...
M. Sarvar Rasheed +3 more
wiley +1 more source
Thermal stability of retained austenite in Quenching & Partitioning steels
, 2015 The drive for ever more safety and fuel efficiency in the automotive industry led the industry to search for steels with enhanced strength and ductility.
Koopmans, T.T.W. (author)
core
, 2013 New carbide free bainitic microstructures are gaining an increasing interest on behalf the scientific and industrial community. The excellent combination of mechanical properties achieved in those microstructures with no need of complex heat treatments ...
García Mateo, Carlos +4 more
core +1 more source