Results 41 to 50 of about 1,940 (222)
Riblet sheaves at Vail, Colorado
Date scanned: 2004-05-17.Vail - Riblet ...
Dwyer, Charles F.
core
Using Bio-Replicated Forming Technologies to Fabricate Shark-Skin Surface
Shark-skin surfaces show the non-smoothness characteristics due to the presence of riblet structures. In this work, biomimetic shark-skins were prepared by means of different bio-replicated forming techniques.
Pu Xia +4 more
doaj +1 more source
Aerodynamic Drag Reduction on Speed Skating Helmet by Surface Structures
The aerodynamic drag for speed skating helmets with surface structures was investigated in this work by using numerical and experimental methods. Computational fluid dynamic (CFD) research was performed to analyze the detail of the flow field around the ...
Yanqing Wang +5 more
doaj +1 more source
ABSTRACT Introduction Suicide risk is markedly elevated following presentation after self‐harm, yet the evidence base for interventions initiated in the immediate post‐presentation period has not been synthesized with specific attention to this high‐risk window. Clarifying which early interventions may reduce adverse outcomes is essential for informing
Guilherme Pimenta Roncete +7 more
wiley +1 more source
Présentation d'un perspectographe stéréographique
Riblet J. Présentation d'un perspectographe stéréographique. In: Revue de géographie de Lyon, vol. 27, n°3, 1952.
Riblet, Jean
core +1 more source
Influence of Wall Deformation Structure on the Liquid Film Flow Behavior Under Turbulent Conditions
ABSTRACT To explore the influence of typical wall deformation structure in the scrubbing‐cooling tube on the liquid film, this paper studied the liquid film flow behavior on the riblet walls with representative riblet radii and compared them with the flat wall. Under different liquid film Reynolds numbers (Rel = 8.3 × 103 ~ 3.14 × 104), the liquid film
Qian Liu +5 more
wiley +1 more source
Effect of Different Flow Directions on Drag over Riblet
Variation in flow direction requires extensive consideration in the practical application of riblet surfaces. However, studies scarcely examine the impact of flow angle α for riblet, which is usually adopted to reduce flow drag.
J. Wang, X. Ren, X. Li, C. Gu, M. Zhang
doaj
KARAKTERISTIK POMPA SENTRIFUGAL DENGAN VARIASI PENAMBAHAN JUMLAH FIN PADA BILAH TIPE SEMI OPEN
Impeller merupakan salah satu bagian terpenting dari pompa sentrifugal yang dapat mempengaruhi performa pompa. Hal yang perlu dilihat dari performa pompa adalah nilai efisiensi, NPSH, Head dan kebisingan dari pompa. Variasi riblet dengaan menambahkan fin
Ahmad kurniawan
doaj +1 more source
Controllable deformation based self‐adaptive drag reduction for complex surface
Reduction of energy consumption and improvement of cruising speed are greatly necessary for underwater vehicles. Previously, regular riblets have been machined and the drag reduction has been verified; however, the riblet parameters are not adjusted like
Dengke Chen, Xianxian Cui, Huawei Chen
doaj +1 more source

