Results 81 to 90 of about 13,797 (255)

Hopping‐Mediated Zero‐Bias Photocharge Retention in Solution‐Processed Van Der Waals Heterostructures

open access: yesAdvanced Functional Materials, EarlyView.
Liquid–liquid interface assembly enables the fabrication of solution‐processed MoS2 and WSe2 centimeter‐scale, nanometer‐thick type‐II heterostructures on paper. Interfacial charge separation and hopping‐limited recombination produce rectification and persistent photocharge retention at zero bias.
Aniello Pelella   +11 more
wiley   +1 more source

Resonant transmission and mode modulation of acoustic waves in H-shaped metallic gratings

open access: yesAIP Advances, 2015
In this work, we demonstrate that resonant full transmission of acoustic waves exists in subwavelength H-shaped metallic gratings, and transmission peaks can be efficiently tuned by adjusting the grating geometry.
Yu-Qiang Deng   +4 more
doaj   +1 more source

Enhanced optical transmission of the triple-layer resonant waveguide structure

open access: yesSemiconductor Physics, Quantum Electronics & Optoelectronics, 2016
In this paper, we propose and demonstrate a novel guided-mode resonant filter based on a metallic grating sandwiched between two dielectric layers for TE polarization. A theoretical model based on rigorous coupled wave analysis has been developed.
I.Ya. Yaremchuk
doaj   +1 more source

Hybrid Ferroelectric Tunnel Junctions with Intrinsic Nonlinearity and Self‐Rectification via Interfacial Reconstruction

open access: yesAdvanced Functional Materials, EarlyView.
Rapid thermal annealing reconstructs the BCFO/Nb:STO interface into an atomically thin reconstructed interfacial layer, which reshapes the tunneling barrier and converts a high‐TER ferroelectric tunnel junction into an intrinsically nonlinear, self‐rectifying device.
Hojin Lee   +21 more
wiley   +1 more source

Amphoteric Cu‐Doping Leading to High Thermoelectric Performance in p‐Type Bismuth Antimony Telluride

open access: yesAdvanced Functional Materials, EarlyView.
This study shows that Cu plays two opposite roles in p‐type Bi0.5Sb1.5Te3 depending on the processing route. Under thermodynamic‐equilibrium bulk‐synthesis, Cu mainly occupies cation sites, increases hole concentration, preserves mobility, and slightly reduces lattice heat transport. The best‐performing composition among the investigated series reaches
Moritz Thiem   +15 more
wiley   +1 more source

D 1 and D 2 resonances in coupled-channel scattering amplitudes from lattice QCD

open access: yesJournal of High Energy Physics
Isospin-1/2 charmed axial-vector D ∗ π − D ∗ η − D s ∗ K ¯ $$ {D}_s^{\ast}\overline{K} $$ scattering amplitudes are computed, along with interactions in several other I = 1/2 J P channels. Using lattice QCD, we work at a light-quark mass corresponding to
Nicolas Lang   +2 more
doaj   +1 more source

Scalable simple liquid deposition techniques for the enhancement of light absorption in thin films: Distributed Bragg reflectors coupled to 1D nanoimprinted textures

open access: yesAIP Advances, 2017
Light trapping within a light absorbing medium is a key to highly efficient thin film solar cells. We propose a large-scale procedure based on materials with low absorption for the fabrication of combined Distributed Bragg Reflector (DBR) and grating ...
B. Brudieu   +5 more
doaj   +1 more source

Sacrificial‐Layer‐Assisted Heat‐Affected‐Zone Suppression in Laser Patterning of PET for High‐Performance Flexible Devices

open access: yesAdvanced Functional Materials, EarlyView.
A removable sacrificial polymer layer engineers the thermal boundary condition during nanosecond laser ablation of PET, suppressing heat‐affected‐zone formation without relying on costly ultrafast lasers. This strategy enables deep, high‐aspect‐ratio trenches with no detectable heat‐affected zone, templating silver‐filled mesh electrodes with record ...
Mehdi Zarei   +3 more
wiley   +1 more source

Influence of Thickness on the Holographic Parameters of H-PDLC Materials

open access: yesInternational Journal of Polymer Science, 2014
For photopolymers the compound concentrations and final thickness of the sample should be known in order to model hologram formation and introduce the reaction-diffusion kinetics of the monomer-polymer system.
S. Gallego   +6 more
doaj   +1 more source

Nitride MXenes Beyond Carbides: Bridging the Gap Between Computational Prediction and Experimental Realization

open access: yesAdvanced Functional Materials, EarlyView.
Nitride MXenes remain constrained by a persistent gap between computational prediction and experimental realization. This Review identifies the thermodynamic, kinetic, and chemical barriers limiting their synthesis, critically evaluates emerging fabrication routes, and proposes a multidimensional computational‐experimental framework to accelerate the ...
Naresh Varnakavi, Masoud Soroush
wiley   +1 more source

Home - About - Disclaimer - Privacy