Results 61 to 70 of about 372,349 (178)
The mechanics of the Rijke tube [PDF]
Quarterly of Applied Mathematics, 1955 openaire +2 more sources
Youngstown Sheet and Tube Company's Campbell Works train depot
, 1920 This image shows the train depot and materials yard of Youngstown Sheet and Tube Company's Campbell Works, ca. 1920-1929. Trains ran continuously through the steel mill, delivering iron ore, limestone, and coal, and departing with finished steel ...
Youngstown Sheet and Tube Company
core
Phytoconstituents screening and antimicrobial activity of the invasive species Nicotiana glauca collected from Al-Baha region of Saudi Arabia. [PDF]
Saudi J Biol Sci, 2021 Ali Alghamdi A.
europepmc +1 more source
Transient Growth and Triggering in the Horizontal Rijke Tube
International Journal of Spray and Combustion Dynamics, 2011 This theoretical paper examines a non-normal and non-linear model of a horizontal Rijke tube. Linear and non-linear optimal initial states, which maximize acoustic energy growth over a given time from a given energy, are calculated. It is found that non-linearity and non-normality both contribute to transient growth and that, for this model, linear ...
openaire +1 more source
Emerging applications of metabolomics in food science and future trends. [PDF]
Food Chem X, 2022 Wu W +6 more
europepmc +1 more source
North Bridge at Youngstown Sheet and Tube Company's Campbell Works
, 1910 This is a photograph of the North Bridge employee entrance at Youngstown Sheet and Tube's Campbell Works, East Youngstown (Campbell), Ohio, ca. 1910-1919. Shown is the gatehouse, gatekeeper, and the bridge that led into the plant. The sign posted above
Youngstown Sheet and Tube Company
core
Deep learning for early warning signals of tipping points. [PDF]
Proc Natl Acad Sci U S A, 2021 Bury TM +6 more
europepmc +1 more source
Youngstown Sheet and Tube Company's Campbell Works
, 1910 A view of the west end of Youngstown Sheet and Tube Company's Campbell Works, in East Youngstown (Campbell), Ohio, ca. 1910-1919. Named after James A. Campbell, the Campbell Works quickly became one of the Mahoning Valley's leaders in producing finished
Youngstown Sheet and Tube Company
core
Model-based control of a Rijke tube combustion instability
, 2005 A Rijke tube is used to demonstrate model-based control of a combustion instability, where controller design is based on measurement of the unstable system. The Rijke tube used was of length 0.75m and had a grid-stabilised laminar flame in its lower half.
Morgans, AS, Dowling, AP, ,
core
Youngstown Sheet and Tube Company's Campbell Works boiler house
, 1912 Refined waste gas is routed to the boiler house to be utilized as fuel to heat water for production of steam. After the boilers were installed, the building was constructed around them.
Youngstown Sheet and Tube Company
core