Results 91 to 100 of about 183,779 (306)

A New Evaluation Circuit with a Low-Voltage Inverter Intended for Capacitors Used in a High-power Three-phase Inverter [PDF]

open access: yes, 2016
016 IEEE Applied Power Electronics Conference and Exposition (APEC 2016), March 20-24, 2016, Long Beach, California, USADC-link capacitors in power electronic converters are a major constraint on improvement of power density as well as reliability ...
Hasegawa, Kazunori   +2 more
core   +1 more source

Artificial Intelligence in Systemic Sclerosis: Clinical Applications, Challenges, and Future Directions

open access: yesArthritis Care &Research, EarlyView.
Systemic sclerosis (SSc) is a rare autoimmune disease defined by immune dysregulation, vasculopathy, and progressive fibrosis of the skin and internal organs. Despite advances in care, major complications such as interstitial lung disease (ILD) and myocardial involvement remain the leading causes of morbidity and mortality.
Cristiana Sieiro Santos   +2 more
wiley   +1 more source

Prediction of PWM-Induced Current Ripple in Subdivided Stator Windings Using Admittance Analysis

open access: yesEnergies, 2019
Subdividing stator winding is a way to lower the DC link voltage value in electric drives and reduce the stress on motor insulation. Coupled windings sharing the same stator teeth are modelled in order to evaluate the link between voltages disparities ...
Antoine Cizeron   +3 more
doaj   +1 more source

Arcjet load characteristics [PDF]

open access: yes
Experiments were conducted to define the interface characteristics and constraints of 1 kW class arcjets run on simulated decomposition products of hydrazine and power processors.
Hamley, John A.
core   +1 more source

Prediction and dynamics of ripples and the bottom boundary layer under combined wave and current flow in the field (poster) [PDF]

open access: yes, 2002
Previously published investigations on the wave bottom boundary layer and ripple geometry are combined to derive a new ripple predictor for flows under waves or under combined wave-current flows.
Padilla-Hernández, R.
core  

Optimal torque control of fault-tolerant permanent magnet brushloss machines [PDF]

open access: yes, 2003
Describes a novel optimal torque control strategy for fault-tolerant permanent magnet brushless ac drives operating in both constant torque and constant power modes.
Atallah, K., Howe, D., Wang, J.B.
core   +1 more source

Rheumatoid Arthritis and Coronary Artery Calcium Progression: A Case Cohort Analysis from ELSA‐Brasil

open access: yesArthritis Care &Research, Accepted Article.
Objective To investigate the association between rheumatoid arthritis (RA) and coronary artery calcium (CAC) prevalence, incidence, and progression over four years in adults without prior cardiovascular disease. Methods A case‐cohort study within ELSA‐Brasil included 585 participants (86 RA, 499 controls). Longitudinal analyses were restricted to those
Patrícia Fonseca Estrada   +7 more
wiley   +1 more source

Design and Analysis of a New Evaluation Circuit for Capacitors Used in a High-Power Three-Phase Inverter [PDF]

open access: yes, 2016
DC-link capacitors in power electronic converters are a major constraint on improvement of power density as well as reliability. Evaluation of the dc-link capacitors in terms of power loss, ageing, and failure rate will play an important role in design ...
Hasegawa Kazunori   +2 more
core   +2 more sources

A Robust Adaptive One‐Sample‐Ahead Preview Super‐Twisting Sliding Mode Controller

open access: yesInternational Journal of Adaptive Control and Signal Processing, EarlyView.
Block Diagram of the Robust Adaptive One‐Sample‐Ahead Preview Super‐Twisting Sliding Mode Controller. ABSTRACT This article introduces a discrete‐time robust adaptive one‐sample‐ahead preview super‐twisting sliding mode controller. A stability analysis of the controller by Lyapunov criteria is developed to demonstrate its robustness in handling both ...
Guilherme Vieira Hollweg   +5 more
wiley   +1 more source

Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling

open access: yesAdvanced Engineering Materials, EarlyView.
Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy