Results 41 to 50 of about 2,672,042 (278)
Rolling contact fatigue (RCF) tests were conducted using rolling bearings with a micro-drilled hole on the raceway. In all the tests, fatigue crack initiated at the edge near the bottom of the hole, and then propagated by shear mode. Even in the unbroken
Sho HASHIMOTO +2 more
doaj +1 more source
Radiative Thermal Management for Extreme Environments: Mechanisms and Design Strategies
In this review, we discuss the fundamental mechanisms of radiative cooling and solar heating, material and structural design strategies, hybrid approaches integrating additional heat transfer pathways, and durability‐oriented designs addressing environmental stresses.
Hyung Rae Kim +5 more
wiley +1 more source
Review of rolling contact fatigue life calculation for oscillating bearings and application-dependent recommendations for use [PDF]
In contrast to the multitude of models in the literature for the calculation of rolling contact fatigue in rotating bearings, literature on oscillating bearings is sparse.
O. Menck, M. Stammler
doaj +1 more source
A constraint‐based analytical framework maps the coupled effects of material properties, structural parameters, and operating conditions in tubular dielectric elastomer pumps for extracorporeal circulatory applications. The approach defines performance boundaries through mechanical, electrical, and hydraulic constraints and identifies feasible design ...
Yan Zhang +3 more
wiley +1 more source
Rolling contact fatigue testing of rolling elements with low saturation temperature lubricants result, in several difficulties. Mainly, uncontrolled phase changes due to flow dynamics often cause difficulties in assessing the lubricant effect on fatigue ...
Balamurugan KARUNAMURTHY, Mark HADFIELD
doaj
The laser shock peening effect and its influence on rolling contact fatigue of ferrite–pearlite steel were investigated experimentally. Microhardness on the steel surface is increased after laser shock treatment.
Yang Zhang, Qinglin Lian, Xi Wang
doaj +1 more source
The objective of this investigation is to evaluate the cyclic plastic deformation response at the subsurface during rolling contact fatigue (RCF) under the conditions of pure rolling and rolling-sliding.
Surajit Kumar Paul +2 more
doaj +1 more source
Compliant Pneumatic Feet with Real‐Time Stiffness Adaptation for Humanoid Locomotion
A compliant pneumatic foot with real‐time variable stiffness enables humanoid robots to adapt to changing terrains. Using onboard vision and pressure control, the foot modulates stiffness within each gait cycle, reducing impact forces and improving balance. The design, cast in soft silicone with embedded air chambers and Kevlar wrapping, offers durable,
Irene Frizza +3 more
wiley +1 more source
The number of rolling elements of a roller bearing influences its operating results, such as contact stress, dynamic load capacity, fatigue life, friction torque, and power loss.
Alexandre da Silva Scari
doaj +1 more source
The development of the methods for modeling the processes of accumulation of the rolling contact fatigue damage and wear of the wheels of the railway rolling stock and the rails is particularly relevant due to the increase in the number of damage in the ...
V. I. Sakalo, A. V. Sakalo
doaj +1 more source

