Results 71 to 80 of about 288,262 (296)
Advanced Engineering Materials, EarlyView.This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Experimental and numerical study of AA5086-H111 aluminum plates subjected to impact [PDF]
, 2013 An experimental and numerical study of medium-velocity impact (within the range of 120 m/s) has been conducted on thin AA5086-H111 aluminum square plates. Targets with different thicknesses (between 2.5 and 4 mm), stratifications and aluminum alloys have
Abdulhamid, Hakim +3 more
core +3 more sources
Advanced Engineering Materials, EarlyView.The subject of this work is the development of a corrosion‐protective coating on steel sheets for form hardening. Rapid heating in an extreme high vacuum (XHV)‐adequate atmosphere is a useful method to prevent oxidation during alloying of 22MnB5 and aluminum to obtain a metallurgical bonding.
Lorenz Albracht +5 more
wiley +1 more source
MATEC Web of Conferences, 2017 Finite element model of tire rolling resistance test on the drum was developed using 3D steady state rolling analysis coupling with pre-inflation of 2D axisymmetric tire analysis.
Suvanjumrat Chakrit, Rugsaj Ravivat
doaj +1 more source
Steady State Analysis and Prediction of Rolling Resistance for a Moving Radial Tire Using Hyper-Viscoelastic Model [PDF]
علوم و تکنولوژی پلیمر, 2014 A 185/65R15 steel belted radial tire was analyzed for the prediction of its rolling resistance using finite element method. The Abaqus code was used for this purpose.
Mir Hamid Reza Ghoreishy, Ghasem Naderi
doaj +1 more source
Tactile on-chip pre-processing with techniques from artificial retinas [PDF]
, 2005 The interest in tactile sensors is increasing as their use in complex unstructured environments is demanded, like in tele-presence, minimal invasive surgery, robotics etc.
Liñán Cembrano, Gustavo +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.Cladding is a proven method that boosts the surface qualities of mechanical parts by applying a layer of more durable material over a base substrate. This work responds to the needs of offshore and pressure vessels sectors by focusing on cladding a super austenitic steel onto low‐carbon steel through gas tungsten arc welding.
E. J. da Cruz Junior +6 more
wiley +1 more source
The mechanisms of pedestrian slip on flooring contaminated with solid particles [PDF]
, 2009 Statistics by the UK Health and Safety Executive (HSE) suggest that slips, trips and falls account for up to one in three major workplace accidents. The vast majority of these accidents are the result of contaminant (fluid or solid) within the shoe-floor
Dwyer-Joyce, R.S. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Mg–Zn composites with a thickness of 0.21 mm were fabricated using roll bonding of a kirigami‐patterned Mg alloy inlay within a Zn matrix. Thermal activation following this process led to the formation of tailored intermetallic structures, which provided the composite with enhanced flexural strength.
Yaroslav Frolov +4 more
wiley +1 more source
Advances in Mechanical Engineering, 2018 Based on Hertz contact theory and one-dimensional Winkler foundation combination with viscoelastic theory, the author derived theoretical formulas of indentation rolling resistance, respectively.
Lu Yan
doaj +1 more source