Results 91 to 100 of about 754,039 (282)
Cell‐Based Biohybrid Micro/Nanorobots for Biotherapy
This review systematically evaluates cell‐based biohybrid micro/nanorobots (CB‐BMRs), highlighting their cell selection criteria, fabrication strategies, and diverse actuation modes. Furthermore, it surveys the promising therapeutic applications of CB‐BMRs in targeted cancer, thrombosis, and inflammation treatments, while comprehensively discussing ...
Lin Wang +11 more
wiley +1 more source
Shear‐Isolating Actuation System for Exosuit Using Movable Pulley With Webbing‐Driven Mechanism
Tendon‐driven exosuits can chafe the skin because the moving tendon slides against the wearer. A shear‐isolating actuation system combining a movable pulley with flat‐profile webbing keeps the body‐contacting tendon layer stationary, relocating relative motion away from the skin. The compact 145‐g actuator delivers 150 N of assistance, and benchtop and
Kyeongmin Lim +5 more
wiley +1 more source
Three types of clad sheets, Cu/Al, Cu/AA5052, and Cu/AA5083, were produced by cold roll bonding with the rolling reduction of 50% and 75%. Tensile shear tests which give tensile shear strength were performed in order to assess the bond strength. Scanning
Yoji Miyajima +3 more
doaj +1 more source
A Shear-Stress Normal-Strain Cycle Relation to Fatigue in Bending, Torsion, and Rolling Contact
Previous work [4] has suggested a shear stress normal strain “potential” as a means of relating stress condition to fatigue of high-strength low-allow steels. Experimental data here permits the rationalization of the theory required in the prior analysis
John Lyman
core +1 more source
This study combines full‐field tomography with diffraction mapping to quantify radial (ε002$\varepsilon _{002}$) and axial (ε100$\varepsilon _{100}$) lattice strain in wrinkled carbon‐fiber specimens for the first time. Radial microstrain gradients (−14.5 µεMPa$\varepsilon \mathrm{MPa}$−1) are found to signal damage‐prone zones ahead of failure, which ...
Hoang Minh Luong +7 more
wiley +1 more source
The Theory Analysis of the Blade Gap’s Adjusting for Rolling Shear
The horizontal blade gap is a key problem in rolling shear. The mathematical model is established in this paper. This model is optimized based on traditional model.
Yu Gui Li +3 more
core +1 more source
Schematic showing a stretchable triboelectric nanogenerator based on interlocked wavy architectures that uses EGaIn microflower‐embedded PVDF‐TrFE and Nylon‐6 nanofiber membranes. The multi‐petaled, electron‐rich EGaIn microflowers enhance interfacial polarization and capacitance, while the interlocked wavy architecture enlarges the effective contact ...
Qianqian Xu +12 more
wiley +1 more source
Lactiplantibacillus plantarum GUANKE remodels the indigenous gut microbiota and is associated with microbiota‐dependent restoration of circulating IAA. IAA treatment attenuates JAK3‐STAT3 and Jag1‐Notch4‐Hey1 signaling and reduces CX3CR1+Ly6C− monocytic precursor generation and pulmonary CD11b+ DC accumulation, together with reduced Th2 inflammation ...
Yujia He +10 more
wiley +1 more source
In this study, the microstructural evolution and mechanical behavior of AISI 430 ferritic stainless steel produced by cold single-roll drive rolling were investigated. By increasing the rolling deformation, the width of the grains decreased, and after 60%
Hossein Aghamohammadi, Roohollah Jamaati
doaj +1 more source
Harnessing Phase Separation for the Development of High‐Performance Hydrogels
ABSTRACT Hydrogels are indispensable for the development of next‐generation bioelectronics, soft robotics, and biomedical devices, where their mechanical properties determine performance and reliability. Among strategies to enhance hydrogel mechanics, phase separation enables controlled heterogeneity resulting in gel networks that are reinforced by ...
Yue Shao +3 more
wiley +1 more source

