Results 1 to 10 of about 172,448 (289)
In this study we analyzed the design changes through increasing vertical angles of the top and bottom plates of the wind inlet of a Savonius rotor, in order to obtain better results and better system performances.
Dejan D. Dinčić, Milan Z. Despotović
doaj +1 more source
Effect of PLL on transient performance of wind turbines generator under voltage phase jump
With the increasing proportion of wind power installed capacity, the influences of transient characteristics of wind turbines generator on safety and stability of power grid is becoming more and more important.
Chao Liu +4 more
doaj +1 more source
Optimal segmented rotor design for the embedded electrical machine for the more electric aircraft
This study presents the design and analysis of the segmented rotor design for an electrical machine embedded onto the more electric aircraft gas turbine engine shaft.
Jenn Yen Loh +5 more
doaj +1 more source
Fluid flow measurement in rotor ventilation ducts
Engineers are constantly developing different ways to cool electrical machines more efficiently. Ventilation ducts/channels are common in the stators of large electrical machines.
Christopher Micallef +2 more
doaj +1 more source
This paper proposes a novel winding layout for the electric machines with fractional-slot concentrated windings (FSCW) using a stator shifting concept, with which all the non-working harmonics can be completely cancelled or significantly reduced and the ...
Shaohong Zhu +4 more
doaj +1 more source
Generator configuration for helicopter quadruplex electric tail rotor
With the move to more electric aircraft (MEA), a key area of investigation is the development of commercially viable systems which are reliable, efficient, low mass, and are compatible and commensurate with the power and multiplex requirements of current
Julian D. Booker +3 more
doaj +1 more source
PWM-based Flux linkage estimation for permanent magnet synchronous machines
Monitoring of rotor temperature in permanent magnet synchronous machines (PMSM) is of great importance as high temperature could cause partial or even irreversible demagnetisation of the permanent magnets (PMs).
Shuai Xiao, Antonio Griffo
doaj +1 more source
The increasing demand for lightweight and high-performance brake rotors has led to the exploration of aluminum–metal matrix composites (Al-MMCs) as alternatives to conventional cast iron rotors.
Samuel A. Awe, Lucia Lattanzi
doaj +1 more source
Slow Recovery of Excitability Increases Ventricular Fibrillation Risk as Identified by Emulation
Purpose: Rotor stability and meandering are key mechanisms determining and sustaining cardiac fibrillation, with important implications for anti-arrhythmic drug development.
Brodie A. Lawson +5 more
doaj +1 more source
Wind turbines should have fault ride through capability, and also it can provide damping for the power grid by improving the control strategy. However, the currently corresponding control strategy is designed independent for the fault voltage through ...
Haiyan Tang +3 more
doaj +1 more source

