Rubber friction: role of the flash temperature [PDF]
, 2006 When a rubber block is sliding on a hard rough substrate, the substrate asperities will exert time-dependent deformations of the rubber surface resulting in viscoelastic energy dissipation in the rubber, which gives a contribution to the sliding friction.
B N J Persson +19 more
core +1 more source
Experimental study on friction coefficients between tire tread rubber and ice
AIP Advances, 2018 The tire tread pattern affects driving significantly on icy roads, and different kinds of rubber pattern mean different friction coefficients when moving on the ice surface.
Yuanchao Zhang, Jingwei Gao, Qiao Li
doaj +1 more source
The Annals of “Dunarea de Jos” University of Galati. Fascicle IX, Metallurgy and Materials Science, 2022 The paper presents a sensitivity study of a rubber circular ring (O-Ring) depending on the value of the coefficient of friction (design parameter) between the ring and the surfaces between which it is mounted.
Doina BOAZU
doaj +1 more source
Effects of stretching on the frictional stress of rubber [PDF]
, 2017 In this paper, we report on new experimental results on the effects of in-plane surface stretching on the friction of Poly(DiMethylSiloxane) (PDMS) rubber with smooth rigid probes.
Chateauminois, Antoine +2 more
core +2 more sources
Analysis of asphalt mix surface-tread rubber interaction by using finite element method
Journal of Traffic and Transportation Engineering (English ed. Online), 2017 The surface texture of the pavement plays a very important role in driving the frictional properties at the tire rubber-pavement interface. Particularly, the hysteretic friction due to viscoelastic deformations of rubber depends mainly on the pavement ...
Santosh Kumar Srirangam +3 more
doaj +1 more source
Study on friction and wear behavior of SAE 1045 steel, reinforced nylon 6.6 and NBR rubber used in clutch disks [PDF]
Materials Research, 2014 The friction and wear properties of AISI 1045 steel, nylon 6.6 composites with different types and percentages of reinforcement and a nitrile rubber, Alpha 66, were submitted to sliding wear tests.
Avital Gabriel de Almeida Rosa +3 more
doaj +1 more source
Experimental Study on Friction Properties of Rubber Material: Influence of Surface Roughness on Sliding Friction [PDF]
, 2007 This study investigated the influence of the surface roughness of rubber on sliding friction. The friction was measured by using textured specimens and plain (non-textured) specimens.
Xu, Fangman +2 more
core +2 more sources
Friction-induced vibration characteristics of water-lubricated rubber bearing
Zhongguo Jianchuan Yanjiu, 2018 [Objectives] The stern tube rubber bearing is an important part of marine propulsion systems. However, under unfavorable low-speed, heavy duty and partial high-temperature working conditions, bad lubrication can occur and cause friction-induced vibration.
PENG Weicai, TAN Yuhang
doaj +1 more source
Research on Friction Vibration of Marine Water Lubricated Rubber Bearing
Tribology Online, 2018 Marine water-lubricated rubber bearing is used to support the stern shaft of surface vessels and underwater vehicles, whose friction vibration and noise directly influence the stealth, security of the vessels and both physical and psychological health of
Jun Yang +4 more
doaj +1 more source
Influence of self-affine roughness on the friction coefficient of rubber at high sliding velocity [PDF]
, 2004 In this work we investigate the influence of self-affine roughness on the friction coefficient of a rubber body onto a solid surface at high speeds.
Palasantzas, G.,
core +2 more sources