Results 21 to 30 of about 38,616 (285)
Micromachines, 2023 Proper mixing in microfluidic devices has been a concern since the early development stages. Acoustic micromixers (active micromixers) attract significant attention due to their high efficiency and ease of implementation.
Vahid Kordzadeh-Kermani +4 more
doaj +1 more source
Numerical simulation of a two-dimensional S-shaped inlet
Journal of Physics: Conference Series, 2022 Abstract In order to solve the problem that different operation conditions affect the performance of S-shaped inlet, we have carried out a numerical study on a two-dimensional S-shaped inlet and analysed the influences of incoming Mach number, attack of angle α and the outlet pressure on the performance parameters of the inlet, such as ...
openaire +1 more source
Results in Engineering, 2023 Three dimensional numerical simulation has been performed to explore the hydro-thermal performance of novel configurations of multichannel (MMCHS) heat sink.
Fatimah Noaman Ghadhban +1 more
doaj +1 more source
Case Studies in Thermal Engineering, 2022 This paper presents a numerical study on the heat transfer performance of U-shaped double-pipe heat exchanger for the concentrated solar power system. The effects of the mass flow rate, temperature and pressure of inlet super-critical CO2 are evaluated ...
Gang Wang +3 more
doaj +1 more source
The Influence of Inlet Swirl on the Flow Within an Annular S-Shaped Duct [PDF]
Volume 1: Turbomachinery, 1996 An experimental investigation has been carried out to determine the effects of inlet swirl on the flow field that develops within an annular S-shaped duct. The duct is representative of that used to connect the compressor spools on multi-spool gas turbine engines.
D. W. Bailey, J. F. Carrotte
openaire +1 more source
The Effect of Inlet Boundary Layer Thickness on the Flow Within an Annular S-Shaped Duct [PDF]
Journal of Turbomachinery, 1998 Experimental and numerical investigations were carried out to gain a better understanding of the flow characteristics within an annular S-shaped duct, including the effect of the inlet boundary layer (IBL) on the flow. A duct with six struts and the same geometry as that used to connect compressor spools on our experimental small two-spool turbofan ...
Toyotaka Sonoda +2 more
openaire +1 more source
Three-Dimensional Fluid–Structure Interaction Case Study on Elastic Beam
Journal of Marine Science and Engineering, 2020 A three-dimensional T-shaped flexible beam deformation was investigated using model experiments and numerical simulations. In the experiment, a beam was placed in a recirculating water channel with a steady uniform flow in the inlet.
Mahdi Tabatabaei Malazi +4 more
doaj +1 more source
Tradeoffs in jet inlet design: a historical perspective
, 2007 The design of the inlet(s) is one of the most demanding tasks of the development process of any gas turbine-powered aircraft. This is mainly due to the multi-objective and multidisciplinary nature of the exercise.
András Sóbester, Sóbester, András
core +1 more source
Research on the matching performance of S-shaped inlet and turbojet engine
Hangkong gongcheng jinzhanThe inlet/engine matching principle of target drone propulsion system is important to evaluate the engine working characteristics. To obtain the inlet/engine matching performance of a target drone, the investigation of the S-shaped inlet and small ...
QUAN Jingge +4 more
doaj +1 more source
Improving the efficiency of a serpentine inlet duct by using of Blowing Jet Vortex Generators flow control technique [PDF]
مجله مدل سازی در مهندسی, 2018 In this research, aerodynamic performance of a double s-shaped serpentine inlet duct is numerically investigated by using of blowing Jet vortex generators flow control technique.
iman Maghsoudi +2 more
doaj +1 more source