The Selection of Leveler Parameters Using FEM Simulation. [PDF]
Materials (Basel), 2023 Mróz S +5 more
europepmc +1 more source
Modeling and Machine Learning of Vibration Amplitude and Surface Roughness after Waterjet Cutting. [PDF]
Materials (Basel), 2023 Leleń M +3 more
europepmc +1 more source
The numerical modeling of failure of S235JR steel using Gurson-Tvergaard-Needleman material model
Roads and Bridges - Drogi i Mosty, 2012 The paper presents assumptions of the Gurson-Tvergaard-Needleman (GTN) model for a porous materials, which is now one of the basic damage material models applied in the analysis of the load-bearing capacity of metal engineering structures. The practical information about the selection of GTN material parameters and performing numerical calculations is ...
openaire +1 more source
Research on environmental impact assessment of flame oxyacetylene welding processes
Metalurgija, 2013 This paper presents the factors that may cause pollution of the work environment when working with the oxyacetylene flame welding process. Experiments were performed using an oven that allows the analysis of all gases resulted in the welding process, but
Gh. Amza +4 more
doaj
The Effect of Blankholder Pressure on the Amount of Springback in the U-Draw Bending Process
Advances in Mechanical and Materials EngineeringSpringback in sheet metal forming processes is a phenomenon that makes it difficult to obtain products with the desired geometry. This paper presents the results of research on the effect of the blankholder pressure on the elastic deformations of sheets ...
Romuald Fejkiel
doaj +1 more source
Using Metal Magnetic Memory to Evaluate the Effect of Welding Method and Weld Temperature on Magnetic Field Strength in Structural Steel. [PDF]
Materials (Basel), 2023 Wieczorska A, Kosoń-Schab A.
europepmc +1 more source
İmalat Teknolojileri ve UygulamalarıThe main challenges in turning are the quality of the machined part and the cost of tooling. Therefore, optimum machining parameters suitable for turning operations should be selected to achieve the desired quality of the finished product with reduced machining time and cost.
Rüstem Binali +3 more
openaire +2 more sources
Effect of cladding parameters on the hardness of bimetal plates
Metalurgija, 2017 Hardness is one of the components responsible for the resistance to wear. The development of new materials with hardness surface more than 65 HRC is possible with use welding technologies.
R. Bęczkowski
doaj
Metalurgija, 2020 The durability of classic structural steels against various types of wear is generally low. Therefore, various types and combinations of resilient materials are constantly evolving, which are designed to reduce the cost of components replacement or ...
J. Kozák +4 more
doaj
Assessment of Selected Structural Properties of High-Speed Friction Welded Joints Made of Unalloyed Structural Steel. [PDF]
Materials (Basel), 2022 Skowrońska B, Chmielewski T, Zasada D.
europepmc +1 more source