Results 91 to 100 of about 295 (161)

Alkali salts of amino acids as alkaline additives for neutralization of acidic corrosion inhibitors. [PDF]

Amino Acids, 2023
Naundorf T, Seddig T, Ruf E, Ballentin L, Kipphardt H, Maison W.   +5 more
europepmc   +1 more source

Assessment of steel S235JR element durability under extremely low-cycle fatigue

Annual of Univercity of architecture, civil engineering and geodesy
Extremely low-cycle fatigue (ELCF) is a process of degradation of steel elements caused by cyclic load leading to plastic deformations significantly above the yield limit. The paper presents an experimental study conducted to identify the failure mechanism under ELCF conditions.
openaire   +1 more source

Modelling of strength processes of S235JR steel at increased temperature [PDF]

Structure and Environment, 2014
Wojciech Skowroński, Agata Włóka, Chmiel, Rafał   +2 more
openaire  

Influence of Innovative Post-Weld Finishing Method on Bead Surface Quality. [PDF]

Materials (Basel), 2023
Dvirna O, Wieczorska A, Abramczyk N, Lesnau A.   +3 more
europepmc   +1 more source

Weldability Assessment of Various Steels by Hard-Facing. [PDF]

Materials (Basel), 2022
Arsić D, Lazić V, Nikolić RR, Sczygiol N, Krstić B, Ivković D, Hadzima B, Pastorek F, Ulewicz R.   +8 more
europepmc   +1 more source

Experimental study on post fire mechanical properties exhibited by S235JR and S355J2+N steel grades

Archives of Civil Engineering
Przedstawiono wyniki badań właściwości mechanicznych typowych stali konstrukcyjnych S235JR oraz S355J2+N po ekspozycji pożarowej. Statyczną próbę rozciągania wykonano na wystudzonych próbkach po uprzednim procesie nagrzewania symulującym oddziaływanie pożarowe.
Piotr Woźniczka, Paulina Zajdel
openaire   +1 more source

Investigation of tensile plastic instability and necking forAL2024T3 aluminum and S235JR steel alloys

, 2020
Tensile plastic instability phenomenon is defined as the mode of deformation so thatlarge amounts of deformation is localized in a certain region of a component duringproduct life or testing procedure. Several studies have been published to assess themethods proposed to predict tensile plastic instability and necking behavior ofmaterials.
openaire   +1 more source

Temperature Measurement during Abrasive Water Jet Machining (AWJM). [PDF]

Materials (Basel), 2022
Bańkowski D, Młynarczyk P, Hlaváčová IM.   +2 more
europepmc   +1 more source

Experimental and Numerical Study of Stirrup Fatigue. [PDF]

Materials (Basel)
Zeidi A, Elleuch K, Atapek ŞH, Konieczny J, Labisz K, Ćwiek J.   +5 more
europepmc   +1 more source

Comparative Analysis of the Application of Five-, Seven- and Nine-Roll Sheet Straightening Using Numerical Tools. [PDF]

Materials (Basel)
Stradomski G, Mróz S, Szota P, Garstka T, Gróbarczyk J, Gryczkowski R.   +5 more
europepmc   +1 more source