Results 81 to 90 of about 1,697 (157)
Numerical Analysis of AgInSe2‐Based Thin‐Film Solar Cells Towards High Efficiency
In this work, SCAPS‐1D is used to numerically explore AgInSe2‐based thin‐film solar cells. Using CuS, WSe2, and AlSb as back surface field (BSF) layers with a CdS window improves carrier separation and built‐in potential. AgInSe2's promise for high‐performance, stable, and environmentally friendly solar applications is demonstrated by the optimised CdS/
Aysha Siddika, Rafiqul Islam Sheikh
wiley +1 more source
Enhancing InGaN Solar Cell Performance Under Concentrated Sunlight: A SCAPS‐1D Simulation Approach
This study investigates the effects of concentrated sunlight on the performance of p-In0.01Ga0.99N/p-InxGa1−xN/n-InxGa1−xN (PPN) solar cells. We explore five InGaN‐based PPN solar cell configurations, characterized by varying indium mole fractions (x=0.1,
Habib Ullah Manzoor +3 more
doaj +1 more source
Simulation of High Efficiency CIGS Solar Cells with SCAPS-1D Software
AbstractIn this paper, the high efficiency Cu(In,Ga)Se2 (CIGS)-based solar cells solar cells was analyzed and designed by SCAPS-1D software. This paper deals with the influence of a buffer layer on the performance of the CIGS-based solar cells. The photovoltaic parameters have been calculated in different buffer layer materials (CdS, ZnS, ZnSe), we ...
Mostefaoui, M. +4 more
openaire +1 more source
Achieving 45% efficiency of CIGS/CdS Solar Cell by adding GaAs using optimization techniques
This paper proposes an efficient three-layered p-GaAs/p-CIGS/n-CdS (PPN), a unique solar cell architecture. Copper indium gallium selenide (CIGS)-based solar cells exhibit substantial performance than the ones utilizing cadmium sulfide (CdS).
Bhatti, Satyam +3 more
core
Phospholipid Interconversion and Transport Are Altered in Glaucoma
Decreased phosphatidylserine (PS) and increased phosphatidylethanolamine (PE) occur in both trabecular meshwork (TM) cells and aqueous humor due to aberrant phosphatidylserine decarboxylase (PSD) over‐expression, and variation in levels of individual PS or PE species differing by only a few acyl chains occurs due to impaired lipid transport due to ...
Genea Edwards +5 more
wiley +1 more source
SCAP-1D : A Spatial Correlation Assessment Procedure from unidimensional discrete data
Abstract Optimal placement of Non-destructive Testing sensors is essential for structure diagnosis as it allows to get maximum information about degradation at minimum cost. Latest optimization methods consider spatial variability of quantities of interest and thus strongly rely on correlation lengths assessment.
Clerc, Romain +2 more
openaire +3 more sources
Structural, Morphological, Optical Properties and Modelling of Ag Doped CuO/ZnO/AZO Solar Cell [PDF]
Copper (II) oxide (CuO) has attained significant attention from researchers because of its unique chemical and physical properties. Ag-doped CuO thin films have been produced on the soda glass substrate (SLG) by spin coating technique at different doping
Baturay, Silan +3 more
core +1 more source
Inorganic CdTe and FeSi2-based solar cells have recently drawn a lot of attention because they offer superior thermal stability and good optoelectronic properties compared to conventional solar cells.
Ali, Md. Hasan +6 more
core +1 more source
This study investigates temperature‐dependent fill factor behavior in CdSeTe/CdTe solar cells to uncover dominant recombination mechanisms. A nonlinear FF(T) trend is observed, explained by the interplay of bulk and interface recombination, strongly influenced by hole mobility and carrier dynamics.
Nadeesha Katakumbura +6 more
wiley +1 more source
Design and simulation of HTL-free CuBi2O4 based thin film solar cells for performance efficiency above 36% [PDF]
The quest for efficient and sustainable energy solutions has propelled the exploration of novel materials and strategies for enhancing the performance of thin-film solar cells (TFSCs).
Aktar, Rima +7 more
core +2 more sources

