Results 91 to 100 of about 6,892 (227)
Characteristics of Scroll Compressor with Driving Bearing Set in Orbiting Scroll
Zhileng xuebao, 2006 The geometric characteristics were analyzed for a scroll compressor with driving bearing set in the orbiting scroll.The final angle and the starting angle for midline of scroll wrap thickness were used for calculating the suction volume,discharge volume ...
李超, 刘振全, 赵荣珍
doaj +2 more sources
Brayton cycle 3.2-inch radial compressor performance evaluation [PDF]
Brayton cycle 3.2 inch radial compressor performance evaluation over wide range of Reynolds ...
Milligan, H. H., Perrone, G. L.
core +1 more source
Zhileng xuebaoTo investigate the vapor injection performance of a scroll compressor with a short profile, a three-dimensional transient numerical model of a vapor-injection scroll compressor for an electric vehicle with a displacement of 38 cm3/r is established and ...
Xia Yang +4 more
doaj
Analysis of Tangential Leakage Flow Characteristics of Oil-Free Scroll Expander for a Micro-Scale Compressed Air Energy Storage System. [PDF]
Entropy (Basel), 2023 Sun J, Peng B, Zhu B, Li Y.
europepmc +1 more source
Geometric Optimization of Scroll Compressors
, 2018 Electric driven scroll compressors are widely used for the A/C systems in electric cars. Besides many other advantages scroll compressors offer comparable good efficiencies and can be used easily in both refrigeration and heat pump mode. Scroll compressors were first introduced in the early 20th century.
Gelke, Wieland +2 more
openaire +1 more source
Effect of inducer inlet and diffuser throat areas on performance of a low pressure ratio sweptback centrifugal compressor [PDF]
A low-pressure-ratio centrifugal compressor was tested with nine combinations of three diffuser throat areas and three impeller inducer inlet areas which were 75, 100, and 125 percent of design values.
Klassen, H. A.
core +1 more source
Applied SciencesThrough the analysis of the adhesion between the tooth head and axial clearance leakage attributed to vortex tooth shape deformation, an innovative tooth shape design concept has been introduced entitled “progressive change tooth high vortex tooth”. This
Bin Yang +5 more
doaj +1 more source
Tribological behaviors of laser textured surface under different lubrication conditions for rotary compressor. [PDF]
Sci Rep, 2023 Ding S, Wei H, Yang O, Deng L, Mu D.
europepmc +1 more source
Zhileng xuebao, 2011 In design and calculation of scroll compressor with symmetrical circular arc plus line-shaped top profile, rotating angle of crankshaft at the very moment when centre compression chamber is formed is totally different from that at the beginning of the ...
Wu Hao +3 more
doaj
Horizontal Scroll Compressor for Refrigeration Applications
, 2021 New efficiency regulations, as well as trends in applications of new low GWP refrigerants, force compressors to be re-designed, especially for A3 refrigerants, because of the regulatory limitations of the refrigerant charge. The paper addresses compressor design allowing for more efficient use of the refrigerant charge.
Antimonov, Mikhail A. +2 more
openaire +1 more source