Results 101 to 110 of about 670,205 (283)

Optimized Time–Frequency Analysis for Induction Motor Fault Detection Using Hybrid Differential Evolution and Deep Learning Techniques

open access: yesInternational Journal of Adaptive Control and Signal Processing, EarlyView.
Workflow of the parameter optimization process for ITSC fault detection, applying Differential Evolution optimization and the Smooth Pseudo Wigner‐Ville Distribution for signal processing. The optimized parameters are then used in the failure identification pipeline, which combines the signal processing with a YOLO‐based architecture for fault severity
Rafael Martini Silva   +4 more
wiley   +1 more source

Investigation of Iron‐Aluminide‐Like Phase Composition in Complex Concentrated Fe32Cu12Ni11Ti16Al29 Alloy

open access: yesAdvanced Engineering Materials, EarlyView.
This work reveals the phase composition and quantitative morphology analysis of precipitation‐hardened Fe32Cu12Ni11Ti16Al29 complex‐concentrated alloy. The precipitates are shown to have a high coherency. Morphology transition between sphere, cuboidal, and elongated morphology is observed. Finally, the overaging behavior is captured using microhardness.
Rostyslav Nizinkovskyi   +4 more
wiley   +1 more source

Impact of Hot Isostatic Pressing on Microstructure Evolution and Creep Performance of Powder Bed Fusion–Laser Beam Processed CM247LC

open access: yesAdvanced Engineering Materials, EarlyView.
The influence of Hot Isostatic Pressing (HIP) temperature on the microstructure and creep performance of powder bed fusion–laser beam processed CM247LC superalloy is investigated. Grain growth and γ’ precipitate evolution are characterized following HIP at varying temperatures.
Ahmed Fardan   +4 more
wiley   +1 more source

Single‐Crystal Castability of CM186LC Nickel‐Based Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
The optimal conditions to obtain single‐crystal (SX) castings of the directional solidification nickel‐based superalloy CM186LC, are investigated. Cylindrical samples are cast via a proprietary SX Bridgman process. The effect of solidification rates (V) ranging from 1 to 10 mm⋅min−1 on the microstructure is explored.
André Baldissera   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy