Results 11 to 20 of about 1,344,359 (262)
Numerical and experimental study of different geometries of expansion-contraction microchannels in particle sorting [PDF]
مجله مدل سازی در مهندسی, 2022 In this paper, a new simulation method (quasi-three-dimensional) is introduced to model devices based on inertial and Magnus forces. Simulations were computed using the COMSOL software.
Hanieh Heidari +3 more
doaj +1 more source
Improving the efficiency of a serpentine inlet duct by using of Blowing Jet Vortex Generators flow control technique [PDF]
مجله مدل سازی در مهندسی, 2018 In this research, aerodynamic performance of a double s-shaped serpentine inlet duct is numerically investigated by using of blowing Jet vortex generators flow control technique.
iman Maghsoudi +2 more
doaj +1 more source
Investigation of effective parameters on capturing particles by secondary flows in rectangular microchannels [PDF]
مجله مدل سازی در مهندسی, 2021 In recent years, inertial microfluidics (the use of inertial forces in microchannels) have attracted much attention aiming particle separation.
Mohammad Mahdi Ghadiri +3 more
doaj +1 more source
Energies, 2020 Thermal performance enhancement in microchannel heat sinks has recently become a challenge due to advancements in modern microelectronics, which demand compatibility with heat sinks able to dissipate ever-increasing amounts of heat.
Safi Ahmed Memon +3 more
doaj +1 more source
Secondary flows in slow granular flows [PDF]
EPJ Web of Conferences, 2017 Recent findings by Krishnaraj and Nott [1] show that a granular material sheared in a cylindrical Couette cell at low shear rates forms a single secondary vortex. The vortex spans the entire width of the Couette cell and has a sense opposite to the centrifugally driven Taylor-Couette vortex in a Newtonian fluid – it is in fact shown to be driven by ...
Dsouza Peter Varun +2 more
openaire +2 more sources
Energies, 2020 This paper discusses the turbulent flow and heat transfer from a uniform air flow with high temperature to the outside through a 90° curved square pipe.
Guanming Guo +10 more
doaj +1 more source
Actuators, 2022 A dielectric barrier discharge plasma actuator was employed to reduce the passage vortex generated in a turbine cascade. This study focused on the burst mode drive of a plasma actuator and examined the relationship between flow field changes and the ...
Takayuki Matsunuma
doaj +1 more source
Entropy, 2019 Flow separation, which often occurs at the junction of blades and endwalls and seriously limits the aerodynamic performance of turbomachinery, is caused mainly by the boundary layer mixing on the blades and endwall surfaces and the transverse secondary ...
Weilin Yi, Lucheng Ji
doaj +1 more source
Compressibility Effects on Secondary Flows [PDF]
Journal of the Aeronautical Sciences, 1956 The method of W. R. Hawthorne for the calculation of the secondary vorticity is generalized for compressible flow. It is shown that in the linearized theory (small vorticity) the influence of compressibility upon the secondary vorticity is due to (1) the entropy gradient in the approaching flow and (2) the compression of the fluid during the ...
openaire +2 more sources
Enhancement in thermo-hydraulic performance of microchannel heat sink with secondary flows of leaf v
Journal of Thermal Engineering, 2020 A new microchannel heat sink (MCHS) design comprising of secondary channels which connect neighboring primary channels are numerically analyzed to study their thermo-hydraulic characteristics.
Vinayak GAIKWAD +3 more
doaj +1 more source