Results 31 to 40 of about 11,924 (213)
Elevation Resolved Elemental Mapping with SEM/EDS [PDF]
Extended abstract of a paper presented at Microscopy and Microanalysis 2009 in Richmond, Virginia, USA, July 26 – July 30 ...
J Konopka, M Betts
openaire +1 more source
Amaç:Bu çalışmanın amacı, farklı konsantrasyonlarda hidrojen peroksit (HP) içeren ofis tipi ağartma ajanlarının mine kalsiyum (Ca) ve fosfor (P) değişimine olan etkilerini taramalı elektron mikroskobu (SEM) ve enerji dağılım X-ışını spektrometrisi (EDS ...
Hanife Altınışık
doaj +1 more source
The medical applications of degradable iron-based biomaterials have been targeted by re-searchers due to their special properties that they present after alloying with various elements and different technological methods of obtaining.
Ana-Maria Roman +10 more
doaj +1 more source
SCANNING ELECTRON MICROSCOPY: AN ESSENTIAL TOOL IN THE INVESTIGATION OF CEMENT FOR OIL WELLS
Oil well cementing plays a critical role in ensuring zonal isolation, structural integrity, and long-term well safety. Due to exposure to high pressures, temperatures, and chemically aggressive environments, understanding the microstructural behavior of ...
Rafael A. Ventura +3 more
doaj +1 more source
Morphological Study of Surface Magnetic Minerals, Case Study of North Banjarmasin Settlement Areas
We have conducted research to identify the morphology of magnetic minerals from the land in the Banjarmasin regional settlement area. We used scanning electron microscopy and energy dispersive X-ray spectroscopy (SEM EDS) on the soil sample to look at ...
Sudarningsih Sudarningsih +3 more
doaj +1 more source
Structural, Morphological and Magnetic Properties of Zn0.5Mg0.5Fe2O4 as Anticorrosion Pigment
Glycine-assisted combustion route used for elaboration spinel Zn0.5Mg0.5Fe2O4. X-ray diffraction (XRD), scanning electron micrographs (SEM), energy dispersive spectrometry (EDS) and infrared (IR) spectroscopy, attributive this ferrite.
N.M. Deraz, Omar H. Abd-Elkader
doaj +1 more source
In the present work, one-step, mass-scale productive solid state reaction method has been employed for the preparation of gadolinium (Gd) doped ZnO (GZOx: x = 0, 2, 4, 6, 8 wt%) nanostructures.
Rajesh Kumar +3 more
doaj +1 more source
Use of SEM and EDS analysis in the investigation of Al-Si-Cu piston alloy cast porosity [PDF]
Porosity formation was detected in the casting thinnest section in the proximity of the as cast surface and near the wall centerline. In order to investigate the cause of the porosity formation light microscopy was used to define as cast structure. After
D. Kakaš +4 more
doaj
Monte Carlo strategy for SEM-EDS micro-nanoanalysis of geopolymer composites
The development, optimization and application of new geopolymer composite materials must necessarily go through a precise and accurate physico-chemical and mineralogical characterization down to the micro and nanoscale.
Daniele Moro +2 more
doaj +1 more source
Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios +5 more
wiley +1 more source

