Results 21 to 30 of about 97,144 (227)

Effectiveness of rTMS on Working Memory and Inhibitory Impairments in Patients With Post‐Stroke Executive Deficits

open access: yesAnnals of Clinical and Translational Neurology, EarlyView.
ABSTRACT Objective Considerable efforts have been dedicated to developing effective treatments for post‐stroke executive impairment (PSEI), among which repetitive transcranial magnetic stimulation (rTMS) has shown great potential. This study aimed to investigate the therapeutic effects of high‐frequency rTMS on working memory (WM) and response ...
Mengting Lao   +6 more
wiley   +1 more source

Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling

open access: yesAdvanced Engineering Materials, EarlyView.
Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer   +3 more
wiley   +1 more source

Continuity of LF-algebra representations associated to representations of Lie groups

open access: yes, 2012
Let G be a Lie group and E be a locally convex topological G-module. If E is sequentially complete, then E and its space of smooth vectors are modules for the algebra D(G) of compactly supported smooth functions on G. However, the module multiplication
Glockner, Helge
core   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

open access: yesAdvanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti   +11 more
wiley   +1 more source

An observer principle for general relativity [PDF]

open access: yes, 2014
We give a mathematical uniqueness theorem which in particular shows that symmetric tensors in general relativity are uniquely determined by their monomial functions on the light cone.
Dupre, Maurice J.
core  

Overview of (pro-)Lie group structures on Hopf algebra character groups

open access: yes, 2017
Character groups of Hopf algebras appear in a variety of mathematical and physical contexts. To name just a few, they arise in non-commutative geometry, renormalisation of quantum field theory, and numerical analysis.
A Connes   +47 more
core   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

open access: yesAdvanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek   +5 more
wiley   +1 more source

Composition‐Tuned Enhancement of the Anomalous Nernst Effect in FeCo–Pt Thin Films on Rigid and Flexible Substrates

open access: yesAdvanced Engineering Materials, EarlyView.
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi   +2 more
wiley   +1 more source

Gauge theory of Faddeev-Skyrme functionals

open access: yes, 2009
We study geometric variational problems for a class of nonlinear sigma-models in quantum field theory. Mathematically, one needs to minimize an energy functional on homotopy classes of maps from closed 3-manifolds into compact homogeneous spaces G/H. The
Dynkin E.   +11 more
core   +1 more source

Multifunctional Crushing and Piezoresistive Self‐Sensing in Conductive Epoxy/CNT‐Coated Polyetherimide TPMS Lattices

open access: yesAdvanced Engineering Materials, EarlyView.
This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy