Results 151 to 160 of about 12,863 (293)
Exploiting Device Deformability for Fluid and Particle Manipulation
Small, EarlyView.Deformable devices enable fluid and particle manipulation modes that are inaccessible to rigid platforms. This review examines soft materials and architectures that translate controlled deformation into microscale fluid operations such as pumping, valving, mixing, and particle handling.
Zhiyang Hong +4 more
wiley +1 more source
Post-buckling Strength of LiteSteel Beams in Shear
, 2009 This paper presents the details of experimental and numerical studies on the shear behaviour of a recently developed, cold-formed steel beam known as LiteSteel Beam (LSB).
Mahendran, Mahen +1 more
core
Phase Transformation Behavior of Continuously Cooled Fe–C–V–(Mo) Alloys
steel research international, EarlyView.Additions of vanadium and molybdenum microalloying are shown to reshape phase transformations in clean low‐carbon steels. By tracking microstructural shifts during continuous cooling, the work uncovers the correlation between transformation kinetics, ferrite morphology, and hardness.
Anastasiya Tselikova +5 more
wiley +1 more source
steel research international, EarlyView.Paint baking of resistance spot welded joints of 2.0 GPa warm‐stamped medium‐Mn steel activates low‐temperature tempering, forming fine cementite in the fusion zone and enhancing toughness. Crack propagation resistance increases, shifting the failure mode from partial interfacial to complete pullout, with peak load and energy absorption rising ...
Sunusi Marwana Manladan +8 more
wiley +1 more source
Foamed Concrete Sealing Materials for Coal Seam Gas Drainage Boreholes: A Review
Safety Science and Technology, EarlyView.This study investigates the sealing performance of foamed concrete in gas drainage boreholes. By comparing leakage pathways (a, c) with sealed systems (b, d), the research demonstrates how foamed concrete effectively fills mining‐induced fractures and resists deformation.
Jiaxing Zou +6 more
wiley +1 more source
Innovative development and structural behavior of hollow columns using inflatable molds
Structural Concrete, EarlyView.Abstract This study introduces a novel approach for constructing hollow columns using precast (PC) methods enhanced by inflatable air tubes as internal molds. The proposed method addresses practical challenges in conventional hollow column construction, such as limited constructability, high production cost, and interference between internal molds and ...
Soo Hyung Kim +3 more
wiley +1 more source
Experimental investigation of reinforced concrete members subjected to reversed cyclic axial loading
Structural Concrete, EarlyView.Abstract This paper presents an experimental campaign of five reinforced concrete members subjected to cyclic axial loading alternating between tension and compression. Fiber optical sensors and digital image correlation, in combination with automated crack detection and measurement, were used to investigate, among other aspects, the development of ...
Simon Karrer +2 more
wiley +1 more source
The performance of Ramped Scarf (RS) and Stepped Scarf (SS) repair schemes for highly loaded composite structures has been extensively studied under compressive, tensile, and flexural loadings.
Cole, D. +3 more
core +1 more source
Structural Concrete, EarlyView.Abstract In practice, reinforced concrete (RC) wall‐like columns often have openings to facilitate building services, which creates stress concentrations around the opening, resulting in the weakening of their load‐carrying capacity. This study proposes innovative strengthening methods using near‐surface mounted (NSM) incorporating steel materials to ...
Ahmed Hamoda +4 more
wiley +1 more source
Instability of composite beams in hogging bending [PDF]
This work is concerned with local buckling and lateral distortional buckling, two aspects of instability that govern the design of composite beams in hogging regions.
Chen, Shiming
core