Results 141 to 150 of about 96,065 (304)
Experimental Factors and Techniques for Pool Boiling Heat Transfer Enhancement: A Critical Review
ABSTRACT This review presents a comprehensive assessment of active strategies for enhancing pool boiling heat transfer, with a focus on techniques that do not rely solely on the boiling surface modification. It examines a broad range of methodologies including fluid additives, external fields, mechanical interventions, and thermal‐geometric tuning that
José E. Pereira +2 more
wiley +1 more source
This study, by examining a typical stratospheric intrusion event that occurred in North China from 30 to 31 July 2021, found that the event led to a sharp increase in near‐surface ozone concentrations by 23 ppbv within 36 h, accounting for 40% of the total observed ozone levels, with localised peaks exceeding 30 ppbv.
Yinghan Sun, Zhicong Yin, Yijia Zhang
wiley +1 more source
Objectives The femoropopliteal (FP) artery is the most frequently revascularized segment in peripheral artery disease (PAD), followed by the iliac segment. Wall shear stress (WSS) is a key local factor implicated in both atherosclerotic plaque formation and restenosis after angioplasty.
Jan Lukas Prüser +5 more
wiley +1 more source
Abstract Benthic incubation chambers enclose a known volume of water overlying a known area to measure water chemistry changes and are typically used to quantify the metabolic activity of benthic organisms or communities. Here we present an economical benthic incubation chamber for shallow, low‐flow environments, built using off‐the‐shelf components ...
Luke D. Groff +2 more
wiley +1 more source
A second-order closure analysis of turbulent diffusion flames [PDF]
A complete second-order closure computer program for the investigation of compressible, turbulent, reacting shear layers was developed. The equations for the means and the second order correlations were derived from the time-averaged Navier-Stokes ...
Beddini, R. A. +2 more
core +1 more source
ABSTRACT Porous gas bearings (PGBs) enable high‐speed, oil‐free operation in modern rotating machinery. This study develops a coupled thermo‐hydrodynamic (THD) model for a cylindrical porous gas bearing lubricated with four working fluids—air, R‐134a, helium and hydrogen.
S. Bechiri, B. Bouchehit, B. Bou‐Saïd
wiley +1 more source
Experimental Study on Polymer–Polymer Interfacial Thermal Resistance
Interfacial thermal resistance (ITR) in polymer–polymer interfaces is experimentally measured in this paper by the multi‐layered bulk sample approach. Based on numerical simulation and experimental verification, new techniques of layer‐overlapping samples are developed.
Yinfeng Xia +2 more
wiley +1 more source
ABSTRACT The planar and radial thermal free jets for forced convection of a non‐Newtonian power‐law fluid are investigated. The thermal diffusivity is dependent on the shear‐rate and is not a constant. The flow in planar and radial thermal free jets is governed by the momentum, continuity and energy balance equations. In the stream‐function formulation,
Avnish Bhowan Magan, Rehana Naz
wiley +1 more source
Interaction Between Vortex‐Induced Vibrations and Base Vibrations in Piezoelectric Harvesters
ABSTRACT In the present era, powering sensors using green energy is a significant challenge. One promising solution for the power supply of small sensors relies on piezoelectric energy harvesters excited by vortex‐induced vibrations (VIVs) generated by wind.
Michele Tonan +3 more
wiley +1 more source
Evaluation Study of Pressure-Strain Correlation Models in Compressible Flow
This paper is devoted to the second-order closure for compressible turbulent flows with special attention paid to modeling the pressure-strain correlation appearing in the Reynolds stress equation.
Aicha Hanafi, H. Khlifi
doaj

