Results 161 to 170 of about 10,643 (314)
ABSTRACT This study investigates the hydrodynamic influence of forward transom tapering on a displacement catamaran hull using computational fluid dynamics (CFD) simulations. Five taper configurations ranging from a vertical transom base design to a fully tapered stern (1.00B) were evaluated over a wide Froude number range (Fr = .3 to 1.0).
Chalermkiat Nuchturee +3 more
wiley +1 more source
Comparison of canola fiber reinforced composites manufactured using water‐retted, field‐retted, and enzyme‐treated fibers. ABSTRACT Canola fibers obtained from discarded stalks through various processing methods, including water‐retting and field‐retting followed by mechanical decortication and enzymatic degradation, were utilized as discontinuous ...
Md Shadhin +2 more
wiley +1 more source
Radar‐plot comparison of consolidation quality and flexural performance of composite laminates manufactured by six vacuum‐infusion routes, evaluated at the resin‐inlet and vacuum‐port regions. ABSTRACT Conventional vacuum‐assisted resin transfer molding (C‐VARTM) is recognized as a cost‐effective resin infusion technique for manufacturing large‐scale ...
Ilhan Kahraman +8 more
wiley +1 more source
Thermoplastic‐Resin Transfer Molding Technology: Development and Challenges Toward Industrialization
Illustration of the key aspects involved in the manufacture of thermoplastic composites by T‐RTM highlighting the relationships between raw materials, resin mixing strategies, polymerization parameters, and processing equipment ranging from laboratory to industrial scale. ABSTRACT Driven by increasingly stringent international environmental regulations,
Filipe P. Martins +4 more
wiley +1 more source
Numerical simulations of unsteady complex geometry flows [PDF]
Numerical simulations have been here carried out for turbulent flows in geometries relevant to electronic systems. These include plane and ribbed channels and a central processor unit (CPU).
Liu, Yan, Ph.D.
core
Near‐resonant excitation of the Adriatic barotropic modes: The seiche events of December 2019
This study examines severe flooding in the northern Adriatic Sea in December 2019, which existing forecasting systems failed to predict. Analysis of wind and sea‐level data, alongside reanalysis datasets and a high‐resolution hydrodynamic model, revealed a wind‐induced resonance mechanism.
Marco Bajo +3 more
wiley +1 more source
A Miniaturized Multi-Parameter Synchronous Observation System for In Situ Ocean Turbulence Measurement. [PDF]
Ouyang W, Zhang Z, Jing J.
europepmc +1 more source
A theory for the interaction between a boundary layer and a low mountain is used to provide estimates of the turbulent orographic form drag, upward‐propagating mountain gravity‐wave drag, and trapped lee‐wave drag (case shown in the figure). After reviewing briefly how these processes are represented in weather and climate models, we propose a ...
Francois Lott +2 more
wiley +1 more source
A primer on direct numerical simulation of turbulence - methods, procedures and guidelines
Direct Numerical Simulation (DNS) is the branch of CFD devoted to high-fidelity solution ofturbulent flows. DNS differs from conventional CFD in that the turbulence is explicitly resolved,rather than modelled by a Reynolds-averaged Navier-Stokes (RANS ...
Sandberg, Richard D., Coleman, Gary N.
core
Evaluating anisotropy‐based Monin–Obukhov similarity theory over canopies and complex terrain
This study shows that an anisotropy‐based generalization of Monin–Obukhov surface‐layer scaling (SC23) applies readily across a wide range of atmospheric conditions with variable terrain, canopies, and land‐cover complexity. This work focuses on the scaling of velocity variances for 7 years at the 47 sites in the National Ecological Observation Network
Tyler S. Waterman +3 more
wiley +1 more source

