Results 271 to 280 of about 2,247,567 (328)
Some of the next articles are maybe not open access.
Lightweight Concrete Modification Factor for Shear Friction
PCI Journal, 2013L. Sneed, D. M. Shaw
semanticscholar +2 more sources
Observed Effects of Interparticle Friction and Particle Size on Shear Behavior of Granular Materials
International Journal of Geomechanics, 2016Jun Yang
exaly +2 more sources
Examination of shear friction design provisions
, 2018Nikkolas Edgmond
semanticscholar +2 more sources
Dense shearing flows of soft, frictional cylinders
Soft Matter, 2022We perform discrete numerical simulations at a constant volume of dense, steady, homogeneous flows of true cylinders interacting via Hertzian contacts, with and without friction, in the absence of preferential alignment.
Berzi D., Buettner K. E., Curtis J. S.
openaire +3 more sources
Friction and Shear Strength of Polymers
A S L E Transactions, 1977The authors have measured the shear strength and friction of a number of polymers. The shear strength measurements were made on thin films of the polymers deposited on hard, smooth substrates. The values of the coefficients of friction obtained from these shear strength measurements have been compared with the values obtained when bulk polymer slides ...
J. K. A. Amuzu, B. J. Briscoe, D. Tabor
openaire +1 more source
FRICTIONAL CONTACT WITH TRANSVERSE SHEAR
The Quarterly Journal of Mechanics and Applied Mathematics, 1986The problem considered is that of a rigid plane indentor pressed into a region ...
openaire +2 more sources
Concepts of Shear Friction Applied to Masonry Shear Walls
The Masonry Society Journal, 2013Currently, the TMS-402 Building Code Requirements for Masonry Structures (2011) contains no provisions for shear friction in concrete and clay masonry wall construction. Various concrete and masonry codes have equations that are primarily based upon Mohr Coulomb theory with a coefficient of friction applied to the summation of the axial load and ...
Shane C. Morrison, Richard M. Bennett
openaire +1 more source
On double shearing in frictional materials
International Journal for Numerical and Analytical Methods in Geomechanics, 2006AbstractThis paper evaluates the mechanical behaviour of yielding frictional geomaterials. The general Double Shearing model describes this behaviour. Non‐coaxiality of stress and plastic strain increments for plane strain conditions forms an important part of this model. The model is based on a micro‐mechanical and macro‐mechanical formulation.
openaire +1 more source
SHEAR FRICTION AND HIGH-STRENGTH CONCRETE
ACI Structural Journal, 2001This paper reports a re-appraisal of available shear friction test data and presents simple, modified shear friction equations suitable for use in design. These equations reflect the influence of concrete strength on shear friction strength. They enable full advantage to be taken of the potentially high-shear-friction strengths of very-high-compressive
A. Mattock
semanticscholar +2 more sources
Anisotropic Elasticity in Sheared Packings of Frictional Disks
2013We study the effect of unilaterality of the interparticle interactions on the elastic response of granular materials. The anisotropy of the contact network is related to the opening of contacts during quasi-static shear deformations. As a result, local incremental constitutive relations describing the evolution of stress in terms of shear and ...
Shaebani, Mohammad Reza +2 more
openaire +1 more source