Results 31 to 40 of about 1,047,159 (304)
The short-circuit response of inverter-interfaced distributed generators (IIDGs) is not adequately represented in many conventional protection studies.
Rasel Mahmud +2 more
semanticscholar +1 more source
Current Sharing of Parallel SiC MOSFETs under Short Circuit Conditions
Device-to-device parametric variations (e.g. threshold voltage VTH, gate resistance RG and junction temperature TJ) can cause variations in the short-circuit currents conducted through parallel-connected devices.
R. Wu +4 more
semanticscholar +1 more source
A Solid-State Circuit Breaker Based on Coupled-Inductor for Battery Energy Storage System
In a battery energy storage system (BESS), short-current protection is critical and need to be designed carefully to enhance the system’s safety and reliability.
Kuo-Yuan Lo +2 more
doaj +1 more source
Research on a fault current limiter based on variable reactor
With the increase of the power load in power grid, the short circuit level continues to rise, and excessive short-circuit current will do great damage to power equipment and imperil power systems.
GU Yu +3 more
doaj +1 more source
Design of high-power intrinsically safe power supply based on fault current change rate
In order to solve the problems of low output power, poor protection effect, and slow dynamic response speed of existing intrinsically safe power supply, a high-power intrinsically safe power supply based on fault current change rate is designed.
KANG Qian +3 more
doaj +1 more source
Like the widely-used semiconductor switch, Insulated Gate Bipolar Transistors (IGBTs) are subject to many failures and degradation in power electronic converters.
Sadegh Mohsenzade +2 more
doaj +1 more source
Most of existing models and methods for research of capacitive circuit spark discharge and high-power intrinsic safety power supply only consider discharge characteristics of energy storage elements during discharge process, and do not consider influence
KANG Qian +3 more
doaj +1 more source
Polycrystalline CdSeTe/CdTe Absorber Cells With 28 mA/cm2 Short-Circuit Current
An 800 nm CdSeTe layer was added to the CdTe absorber used in high-efficiency CdTe cells to increase the current and produce an increase in efficiency. The CdSeTe layer employed had a band-gap near 1.41 eV, compared with 1.5 eV for CdTe.
A. Munshi +8 more
semanticscholar +1 more source
Research on Measures to Limit Short-Circuit Current by Renovating the Equipment of the Power Grid
This paper addresses the increasingly severe issue of exceeding short-circuit current limits brought about by the rapid development of large power grids.
Shuqin Sun +5 more
doaj +1 more source
Using bi-directional converters for traction power supply in urban rail transit, traditional PWM rectifiers cannot meet the requirement of DC feeder protection for 27 kA short-circuit current with 120 ms continuous time.
WANG Xiong +3 more
doaj

