Results 101 to 110 of about 1,104,401 (339)
Viktoriia Shtefan, Thorgund Nemec, Ute Hempel, Annett Gebert and coworkers demonstrate that anodic treatment of Ti–Cu‐based metallic glass in a nontoxic pyrophosphate electrolyte forms a protective bilayered Ti/Zr‐oxide film enriched with Cu nanocrystals.
Viktoriia Shtefan +8 more
wiley +1 more source
This paper puts forward a selection principle and an optimization configuration method for short-circuit current-limiting measures to address the increasingly severe short-circuit current-exceeding problem brought about by the high-speed development of ...
Shuqin Sun +5 more
doaj +1 more source
Reduction of Electromagnetic Force in AC Distributed Winding of Fault Current Limiter under Short-Circuit Condition [PDF]
Asef Ghabeli +3 more
openalex +1 more source
Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source
Early detection of internal short circuit which is main cause of thermal runaway in a lithium-ion battery is necessary to ensure battery safety for users.
Minhwan Seo +3 more
doaj +1 more source
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Current studies on the mechanical abuse of lithium-ion batteries usually focus on the mechanical damage process of batteries inside a jelly roll. In contrast, this paper investigates the internal short circuits inside batteries.
Sheng Yang +4 more
doaj +1 more source
A Revised Model for Calculating HV Cable Sheath Current Under Short-Circuit Fault Condition and Its Application for Fault Location—Part 1: The Revised Model [PDF]
Mingzhen Li, Chengke Zhou, Wenjun Zhou
openalex +1 more source
An Experimental High‐Throughput Approach for the Screening of Hard Magnet Materials
An entire workflow for the high‐throughput characterization and analysis of compositionally graded magnetic films is presented. Characterization protocols, data management tools and data analysis approaches are illustrated with test case Sm(Fe, V)12 based films.
William Rigaut +16 more
wiley +1 more source
Process Research on Polycrystalline Silicon Material (PROPSM) [PDF]
Results of hydrogen-passivated polycrystalline silicon solar cells are summarized. Very small grain or short minority-carrier diffusion length silicon was used.
Culik, J. S., Wrigley, C. Y.
core +1 more source

