Results 141 to 150 of about 181,114 (210)
Phase Selection Method for 10 kV Three-Core Cables Under Single-Phase Grounding Fault Transient Based on Surface Magnetic Field Sensing. [PDF]
Wang H +6 more
europepmc +1 more source
Transmission line fault detection and classification using bi-orthogonal wavelet transform (5.5) based signal decomposition. [PDF]
Chothani N +7 more
europepmc +1 more source
State estimator and convolutional neural networks-based fault localization approach for modern grids. [PDF]
Bhutto JA +7 more
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Detection of Interturn Short-Circuit Fault for PMSM With Simple Fault Indicator
IEEE Transactions on Energy Conversion, 2016Interturn short-circuit fault is a kind of initial failure of the permanent magnet synchronous motor (PMSM) and serious consequences may be caused if it is left undetected. In this letter, a simple fault indicator is defined as the sum of the absolute values of amplitude differences between the stator currents, where the amplitudes of fundamental ...
Jun Hang +2 more
exaly +2 more sources
Short-circuit fault analysis on microgrid
2015 International Conference on Renewable Energy Research and Applications (ICRERA), 2015This paper presents, a fault simulation on a microgrid consisting of a wind turbine, a solar panel and fuel cell. The power produced by different sources is combined on the same DC bus and converted to AC form using a three phase inverter in order to transfer it to 3-phase AC load. The system takes some precautions against some undesired situations. In
IRMAK, ERDAL +3 more
openaire +2 more sources
A novel fault detection circuit for short-circuit faults of IGBT
2011 Twenty-Sixth Annual IEEE Applied Power Electronics Conference and Exposition (APEC), 2011This paper proposed a novel fault detection circuit comparing the gate voltage of IGBT. The proposed scheme is operated to protect IGBT under short-circuit faults such as hard switch-fault (HSF). The proposed circuit consists of two parts. One is the difference generator which generates a difference between a gate voltage and an input voltage.
Min-Sub Kim +3 more
openaire +1 more source

