Results 241 to 250 of about 16,284 (296)
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Alkali silica reactivity of agglomerated silica fume
Cement and Concrete Research, 2007It is commonly accepted that replacement of a portion of cement in mortar or concrete with well-dispersed silica fume reduces expansion caused by alkali silica reaction. Recently there has been much discussion that large, agglomerated particles of silica fume may actually act as alkali silica reactive aggregates, thereby increasing expansion rather ...
Andrew J Maas +2 more
exaly +2 more sources
Determination of crystalline silica in silica fume
Talanta, 1994Silica fume is formed as a by-product in the manufacture of silicon from quartzite. This paper describes an analytical method for the determination of crystalline silica in silica fume. The crystalline silica was determined after removal of amorphous silica from the fume. A gravimetric method was developed for the determination of the total crystalline
A, Fletcher, D, Phillips, I, Barrow
openaire +2 more sources
Polydimethylsiloxane at the interfaces of fumed silica and zirconia/fumed silica
Applied Surface Science, 2007Abstract Polydimethylsiloxane (PDMS)/fumed silica A-300 and PDMS/ZrO2/A-300 were studied using adsorption, thermogravimetry, temperature-programmed desorption (TPD) mass-spectrometry, infrared spectroscopy, XRD, and broadband dielectric relaxation spectroscopy. ZrO2 was synthesized on fumed silica with zirconium acetylacetonate in CCl4 at 350 K for 1
V.M. Gun’ko +7 more
openaire +1 more source
Wet-Mix silica Fume Shotcrete: Effect of Silica Fume Form
"SP-132: Fly Ash, Silica Fume, Slag, and Natural Pozzolans and Natural Pozzolans in Concrete - Proceedings Fourth Interna", 1992This study investigated the influence of the different forms of silica fume on the plastic and hardened porperties of wet-mix shotcrete. The silica fume forms studied were: uncompacted silica fume; compacted low density silica fume; compacted high density silica fume.
openaire +1 more source
Morphology and surface properties of fumed silicas
Journal of Colloid and Interface Science, 2005Several series of fumed silicas and mixed fumed oxides produced and treated under different conditions were studied in gaseous and liquid media using nitrogen and water adsorption-desorption, mass spectrometry, FTIR, NMR, thermally stimulated depolarization current (TSDC), photon correlation spectroscopy (PCS), zeta potential, potentiometric titration,
V M, Gun'ko +18 more
openaire +2 more sources
Cycloolefin copolymer/fumed silica nanocomposites
Journal of Applied Polymer Science, 2010AbstractWe prepared cycloolefin copolymer (COC)/fumed silica nanocomposites by melt compounding to study the effect of the filler dimensions (filler surface area) on the physical properties, with particular attention to their thermal, mechanical, and optical behaviors.
Dorigato, Andrea +4 more
openaire +2 more sources
Journal of Colloid and Interface Science, 2001
Fumed silica was surface treated by hexyl (C6), octyl (C8), decyl (C10), hexadecyl (C16), and octadecyl(C18)trimethoxysilanes, and the products were evaluated from various aspects. The amounts of alkyl group introduced on silica surface were all within the range from 22 to 25 mmol/100 g.
H., Shirono +3 more
openaire +2 more sources
Fumed silica was surface treated by hexyl (C6), octyl (C8), decyl (C10), hexadecyl (C16), and octadecyl(C18)trimethoxysilanes, and the products were evaluated from various aspects. The amounts of alkyl group introduced on silica surface were all within the range from 22 to 25 mmol/100 g.
H., Shirono +3 more
openaire +2 more sources

