Results 51 to 60 of about 232 (146)
Deformation Inhomogeneities of a Hypoeutectic Aluminum-Silicon Alloy Modified by Electron Beam Treatment. [PDF]
Materials (Basel), 2023 Ustinov A +7 more
europepmc +1 more source
CENTRIFUGAL CASTING OF ANTIFRICTION SILUMIN
Литьë и металлургия, 2010 It is shown that the way of centrifugal casting into water-cooled mould with vertical rotation axis enables to receive hollow slugs with diameter 100–250 mm, with height under 200 mm with wall thickness under 15 mm of antifriction silumin АК15М3, which will replace expensive antifriction bronze.
V. Ju. Stetsenko +2 more
openaire +1 more source
Determination of Saturation Conditions of the Aluminum Metal Matrix Composites Reinforced with Al<sub>2</sub>O<sub>3</sub> Sinter. [PDF]
Materials (Basel), 2023 Szymański P +4 more
europepmc +1 more source
Успехи физики металлов, 2018 Methods of contemporary physical materials science are applied for the analysis of structural and phase states, tribological and mechanical properties of hypoeutectic silumin treated by electron beams with parameters as follow: energy density — 10–35 J ...
Yu. F. Ivanov, V. Е. Gromov, S. V. Konovalov, D. V. Zagulyaev, Е. А. Petrikova, А. P. Semin
doaj +1 more source
Calorimetric Method for the Testing of Thermal Coefficients of the TIG Process. [PDF]
Materials (Basel), 2022 Mróz M +4 more
europepmc +1 more source
Determination of linear expansion of AlSi10Mg aluminium alloy depending on external conditions during solidification. [PDF]
Heliyon, 2022 Radkovský F +6 more
europepmc +1 more source
Studies of High Tension Silumins
The Journal of the Japan Institute of Metals, 1939 New high tension Silumins were investigated by properly adding several elements, such as Mg, Mn, Cu, Cd, Cr, Sn, Sb, Zn, and Fe in Al-Si alloys, and tested mechanical and anti-corrosion properties on 45 kinds of these alloys. As the base alloy, Al-Si-Mg alloy was taken because Mg is the indispensable element for precipitation hardening effect. Al-Si-Mg
openaire +2 more sources
Литьë и металлургия, 2015 The effect of heat treatment on the structure of the eutectic Al-Si-alloy, a theoretical substantiation process based on thermal analyzer and cooked microstructures was presented in this paper.
A. Anikin +5 more
doaj
MAIN PROBLEMS OF MOULDING OF SILUMINS. WAYS OF SOLUTION
Литьë и металлургия, 2016 The main problems of silumin’ moulding are connected with insufficient modifying of casting structure, their considerable inclination to gas porosity, difficult to remove nonmetallic inclusions and these features are shown in the article.
E. I. Marukovich, V. Yu. Stetsenko
doaj
NEW ANTIFRICTION SILUMIN AK15M3
Литьë и металлургия, 2009 It is shown that billets out of antifrictional silumin AK15M3, obtained by iterative casting in stationary crystallizer with j t system of cooling, surpass in frictional wear resistance similar ones out of antifrictional aluminium bronze and can be used as its substitute in friction units.
V. Ju. Stetsenko, A. I. Rivkin
openaire +1 more source