Results 131 to 140 of about 2,707,349 (312)
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source
Optimization of HOTAS Joystick Design Based on Virtual Simulation
Applied SciencesTo address the lack of effective ergonomic evaluation methods for HOTAS (Hands-On Throttle And Stick) control sticks in dynamic operation scenarios, this study proposes a virtual hand motion data acquisition system based on Unreal Engine 5, combined with
Yaqing Fan +3 more
doaj +1 more source
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez +5 more
wiley +1 more source
Conceptual simulation design [PDF]
, 2007 The work presented in this thesis considers the issues related to the design and implementation of the rotor blade production facility at Rolls-Royce.
Ochwa, Michael O,
core
A Simulation-Based Approach To Spiral Pump Design
International Journal of Applied Sciences and Smart TechnologiesThe consistent availability of irrigation water in agricultural areas remains a challenge to this day, due to the fact that rivers are always located at a lower elevation than farmland.
Hengky Luntungan +2 more
doaj +1 more source
Simulation-based design and characterization of a microwave applicator for MR-guided hyperthermia experimental studies in small animals. [PDF]
Biomed Phys Eng Express, 2020 Faridi P, Bossmann SH, Prakash P.
europepmc +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Design of a Virtual Articulator for the Simulation and Analysis of Mandibular Movements in Dental CAD/CAM [PDF]
, 2009 Organised by: Cranfield UniversityThis paper presents a research project aiming at designing a Virtual Articulator in order to simulate and analyze mandibular movements of the human jaw.
Muniozguren, J. +4 more
core
Optimization Design of Train-mounted Cabinet Based on FEM Simulation
Kongzhi Yu Xinxi Jishu, 2014 It put forward an optimal integrated design method for train-mounted cabinet, whose basic principle is using the structure simulation model. The pointer algorithm is used to find the optimal solution by integrating Abaqus to carry on the static strength ...
ZHANG Chenlin +4 more
doaj
Constructing Reality: Comparing Simulation Modalities in Initial Teacher Education
Education SciencesSimulation-based learning (SBL) is increasingly used within Initial Teacher Education (ITE) to bridge the gap between theory and practice, enhancing pre-service teachers’ (PSTs) preparedness for the complexities of classroom practice. Despite its growing
Rachel Fossey +11 more
doaj +1 more source