Results 131 to 140 of about 672,616 (313)

Adaptive Observer for Coupled Wave PDE and Infinite ODE With Sampled Data and Unknown Input: Application to Brain Hemodynamics Estimation

International Journal of Adaptive Control and Signal Processing, EarlyView.
This article proposes a convergent adaptive observer for a damped wave PDE and an infinite‐dimensional ODE coupled in cascade using sampled‐in‐space ODE state measurements. The proposed observer estimates the distributed states of the PDE and ODE along with unknown PDE parameters and spatial input.
Zehor Belkhatir, Sarah Mechhoud, Taous‐Meriem Laleg‐Kirati   +2 more
wiley   +1 more source

Nautical traffic simulation with multi-agent system

, 2013
This paper describes a microscopic nautical traffic simulation model based on multi-agent system. The ship traffic is produced from the behavior of autonomous agents that represent ships.
Coen van Gulijk, Han Ligteringen, Fangliang Xiao, Van Gulijk, Coen, Ale, B.J.M. (author), Ale, B. (author), Ale, B.J.M., Ligteringen, H. (author), Van Gulijk, C. (author), Xiao, F. (author), Ligteringen, Han, Van Gulijk, C., Xiao, F., Ben Ale, Xiao, Fangliang, Ale, Ben, Ligteringen, H.   +16 more
core   +1 more source

Simulation-Based Design and Optimization of Rectangular Micro-Cantilever-Based Aerosols Mass Sensor. [PDF]

Sensors (Basel), 2020
Xu F, Wei Y, Bian S, Wang H, Chen DR, Kong D.   +5 more
europepmc   +1 more source

Mechanochemical Synthesis and Characterization of Nanostructured ErB4 and NdB4 Rare‐Earth Tetraborides

Advanced Engineering Materials, Volume 27, Issue 6, March 2025.
ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur, Faruk Kaya, Bora Derin, Mustafa Lütfi Öveçoğlu, Ju Li, Duygu Ağaoğulları   +5 more
wiley   +1 more source

Studies on SI engine simulation and air/fuel ratio control systems design [PDF]

, 2013
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.More stringent Euro 6 and LEV III emission standards will immediately begin execution on 2014 and 2015 respectively.
Bai, Yang, Yang Bai
core  

Revisiting Stability Criteria in Ball‐Milled High‐Entropy Alloys: Do Hume–Rothery and Thermodynamic Rules Equally Apply?

Advanced Engineering Materials, Volume 27, Issue 6, March 2025.
The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez, Alejandro F. Manchón‐Gordón, Antonio Vidal‐Crespo, Rafael Caballero‐Flores, Jhon J. Ipus, Clara F. Conde   +5 more
wiley   +1 more source

Simulation-based design and characterization of a microwave applicator for MR-guided hyperthermia experimental studies in small animals. [PDF]

Biomed Phys Eng Express, 2020
Faridi P, Bossmann SH, Prakash P.
europepmc   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

Advanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi, Pasquale Guglielmi, Gianfranco Palumbo, Giuseppe Carbone   +3 more
wiley   +1 more source

Modelling and simulation-based design of a distributed DEVS simulator [PDF]

Proceedings of the 2011 Winter Simulation Conference (WSC), 2011
Eugene Syriani, Hans Vangheluwe, Amr Al Mallah   +2 more
openaire   +1 more source

Laser Powder Bed Fusion of Alumina: Effects of Scanning Strategies on External and Internal Defects

Advanced Engineering Materials, EarlyView.
This study investigates how scanning strategies affect pure alumina in laser powder bed fusion. Linear 45° scanning yields uniform surfaces but high porosity, while the island‐concentric strategy provides higher density with through‐holes favorable for infiltration. Findings highlight pathways toward optimizing defect‐free alumina parts.
Mohamed Abdelmoula, Gökhan Küçüktürk, Duran Kaya, David Grossin, Christophe Tenailleau, Benjamin Duployer, Enrique Juste, Fabrice Petit   +7 more
wiley   +1 more source