Parameter estimation of electric power transformers using Coyote Optimization Algorithm with experimental verification [PDF]
In this work, the Coyote Optimization Algorithm (COA) is implemented for estimating the parameters of single and three-phase power transformers. The estimation process is employed on the basis of the manufacturer's operation reports.
Abaza, Amlak +4 more
core +1 more source
An alternative for reducing the layers in the construction of three-phase planar transformers [PDF]
A modified winding layout for three-phase transformers with PCB windings is proposed in this paper. This modified layout can be used in high current transformers with many PCB layers to simplify the fabrication process.
Asensi Orosa, Rafael +5 more
core +1 more source
Experimental simulation analysis for single phase transformer tests
Transformer is one of main components in electrical power system which role to increase or reduce voltage. Characteristics of transformer would be vital to ensure the voltage is fully transferred. A single-phase transformer is a type of power transformer that utilizes single-phase alternating current, meaning the transformer relies on a voltage cycle ...
Ali Hamoodi +2 more
openaire +3 more sources
Magnetostrictive deformation of a transformer: a comparison between calculation and measurement [PDF]
Magnetostriction, which refers to the deformation of the core material of transformers and electrical machines, is a main contributor to the total noise.
Dirckx, Joris +4 more
core +1 more source
Characterization of Few Mode Fibers by OLCI Technique [PDF]
International audienceAll LP modes of a few mode fiber are simultaneously characterized using phase-sensitive optical low-coherence interferometry. The differential modal group delay and absolute chromatic dispersion values of each mode are retrieved ...
Gabet, R. +7 more
core +3 more sources
Turn-to-turn fault protection technique for synchronous machines without additional voltage transformers [PDF]
This paper presents a novel protection technique for the detection of inter-turn faults in synchronous machines. It is based on the calculation of voltage in the stator windings from the usual phases and neutral voltage, typically available in ...
Gyftakis, Konstantinos N. +2 more
core +1 more source
Optimal passive filter design for effective utilization of cables and transformers under non-sinusoidal conditions [PDF]
Transformers and cables have overheating and reduced loading capabilities under non-sinusoidal conditions due to the fact that their losses increases with not only rms value but also frequency of the load current.
Aleem, SHEA +3 more
core +1 more source
A Solid State Transformer model for power flow calculations [PDF]
This paper presents the implementation of a Solid State Transformer (SST) model in OpenDSS. The goal is to develop a SST model that could be useful for assessing the impact that the replacement of the conventional iron-and-copper transformer with the SST
Guerra Sánchez, Luis Gerardo +1 more
core +2 more sources
STUDY AND DESIGN OF SINGLE PHASE CONVERTER USING OF SINGLE PHASE TRANSFORMER
The field of electrical transformer are most important equipment which is use to convert ac voltage or current like lower to higher , higher to lower without change in the frequency . its primary side and secondary side are isolate from each other and it can higher or lower voltage level the apparent value of electrical passive element like inductive ,
Prof. G.R.Kumrey, Dr. S. K. Mahobia
openaire +2 more sources
Enhanced Electric Vehicle Integration in the UK Low Voltage Networks with Distributed Phase Shifting Control [PDF]
Electric vehicles (EV) have gained global attention due to increasing oil prices and rising concerns about transportation-related urban air pollution and climate change.
Denai, Mouloud, Vega-Fuentes, Eduardo
core +3 more sources

