Results 21 to 30 of about 101 (92)

Control of arc suppression devices for reducing powerline bushfires in resonant grounded power distribution networks using global terminal sliding mode controller

open access: yesIET Generation, Transmission & Distribution, 2023
This paper proposes a global terminal‐sliding mode controller (GT‐SMC) to compensate powerline bushfires due to electric faults in power distribution networks using arc suppression devices (ASDs).
Tushar Kanti Roy, Md Apel Mahmud
doaj   +1 more source

COMPARISON OF EARTHING TECHNIQUES FOR SINGLE LINE TO GROUND FAULT IN 11 kV DISTRIBUTION SYSTEM USING SIMULINK [PDF]

open access: yesJournal of Engineering and Sustainable Development, 2019
In this paper, a new smart earthing method was proposed to reduce the current magnitude of single line to ground fault and thus reduce the damage caused by this fault. Traditional methods of earthing system were studied and compared with the proposed new
Ali Abdulabbas Abdullah   +2 more
doaj   +1 more source

A Hybrid Data-Driven Approach for Locating Single-Line-to-Ground Faults in Distribution Systems

open access: yesIEEE Access
In distribution systems, finding the exact location of a fault can be challenging due to uneven load distribution and different grounding methods. This paper introduces a hybrid data-driven method that uses data obtained from fault-induced transients to ...
Guan-Yi Li   +4 more
doaj   +1 more source

Active Fault-Locating Scheme for Hybrid Distribution Line Based on Mutation of Aerial-Mode Injected Pulse

open access: yesEnergies
Due to the overlap of initial traveling wave signals, the traveling wave propagation process in hybrid distribution lines is complicated to analyze. The most significant challenge posed by the traditional passive traveling wave-locating method for hybrid
Zhuang Jiang   +5 more
doaj   +1 more source

Optimizing Na and Rb Incorporation Along With Bandgap Grading for High Efficiency Ultra‐Thin CIGSe Solar Cells

open access: yesProgress in Photovoltaics: Research and Applications, EarlyView.
In this work, Na and Rb are incorporated into ultra‐thin Cu(In,Ga)Se2 (< 500 nm). By systematically varying the Rb content and combining predeposited Na with postdeposited Rb, we identify the optimal configuration, achieving solar cell efficiencies of 11.72% on Mo and 10.48% on ITO. Through electrical and compositional measurements, a mechanistic model
Christoph Rath   +2 more
wiley   +1 more source

Effect of Neutral Grounding Protection Methods for Compensated Wind/PV Grid-Connected Hybrid Power Systems

open access: yesInternational Journal of Photoenergy, 2017
The effects of the wind/PV grid-connected system (GCS) can be categorized as technical, environmental, and economic impacts. It has a vital impact for improving the voltage in the power systems; however, it has some negative effects such as interfacing ...
Nurettin Çetinkaya, Farhana Umer
doaj   +1 more source

Identifying Suitable Front Contacts for High‐Efficiency Cd(Se,Te) Solar Cells on Space‐Qualified Cover Glass

open access: yesProgress in Photovoltaics: Research and Applications, EarlyView.
Front contact selection governs interfacial stability in CdTe‐based (Cd(Se,Te)) solar cells on ultra‐thin space‐qualified cover glass. Optimized TCO/emitter combinations suppress interdiffusion and deliver up to 16.2% AM0 efficiency with high specific power, demonstrating strong potential for lightweight space photovoltaics.
Aesha P. Patel   +17 more
wiley   +1 more source

Scalable Room‐Temperature Terahertz Graphene Cameras

open access: yesSmall Methods, EarlyView.
ABSTRACT Terahertz (THz) imaging has emerged as a powerful tool for non‐destructive, label‐free analysis across several scientific disciplines, ranging from materials science to biomedical research. By capturing the spatial‐dependent information in a broad range of frequencies, this technique enables the identification of chemical composition ...
Lili Shi   +2 more
wiley   +1 more source

Survey on Compositional 3D Indoor Scene Generation

open access: yesComputer Graphics Forum, EarlyView.
This survey provides a comprehensive overview of compositional 3D indoor scene generation, introducing a unified framework for categorizing existing methods, comparing their strengths and limitations and identifying key challenges and future research directions.
H. I. I. Tam   +7 more
wiley   +1 more source

General Variational Formulation of Axisymmetric Capillary Bridges: Modeling Contact Angle Hysteresis and Capillary Forces

open access: yesInternational Journal for Numerical and Analytical Methods in Geomechanics, Volume 50, Issue 12, Page 4879-4892, 25 August 2026.
ABSTRACT This work presents a general framework for deriving the Young–Laplace equation and the Young's equations for an axisymmetric capillary bridge between two parallel plates by minimizing the system's total energy. These Young's equations naturally emerge as boundary conditions associated with the Young–Laplace equation.
Olivier Millet   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy