Results 101 to 110 of about 443,204 (308)
Modeling, implementation and analysis of a high (six) phase self excited induction generator
Journal of Electrical Systems and Information Technology, 2018 Dual d-q model of six phase-self excited induction generator (6Ph-SEIG) developed in stationary reference frame is proposed in this paper. Developed model, implemented in terms of a simulation model, is utilized to evaluate no-load and on-load ...
M. Faisal Khan +2 more
doaj +1 more source
Sensors, 2020 This paper deals with the torque ripple minimization method based on the modulation of the phase currents of the permanent-magnet synchronous motor (PMSM) drive.
Cezary Jędryczka +2 more
doaj +1 more source
An educational tool to assist the design process of switched reluctance machines [PDF]
, 2016 The design of electric machines is a hot topic in the syllabuses of several undergraduate and graduate courses. With the development of hybrid and electrical vehicles, this subject is gaining more popularity, especially in electrical engineering ...
García Espinosa, Antonio +2 more
core +2 more sources
Development of an experimental six-phase induction machine drive
, 2021 Electrical machines with more than three phases are usually called multiphase electrical machines and they can have several advantages compared to conventional three-phase electrical machines such as a lower content of space-harmonics, lower torque ripple and better fault tolerance.
openaire +1 more source
Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies
Advanced Engineering Materials, EarlyView.Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo +3 more
wiley +1 more source
Multidirectional Power Flow Control among Double Winding Six-Phase Induction Machine Winding Sets [PDF]
This paper presents an indirect rotor-field oriented control (IRFOC) algorithm for symmetrical six-phase double-winding induction machines with four three-phase sub-winding sets.
Abduallah, AA, Dordevic, O, Jones, M
core
Self-Organized Synchronization and Voltage Stability in Networks of Synchronous Machines
, 2013 The integration of renewable energy sources in the course of the energy transition is accompanied by grid decentralization and fluctuating power feed-in characteristics. This raises new challenges for power system stability and design.
Friedrich, Rudolf +3 more
core +1 more source
Turn-to-turn fault protection technique for synchronous machines without additional voltage transformers [PDF]
, 2017 This paper presents a novel protection technique for the detection of inter-turn faults in synchronous machines. It is based on the calculation of voltage in the stator windings from the usual phases and neutral voltage, typically available in ...
Gyftakis, Konstantinos N. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
An Application for Research: the Large Hadron Collider
, 2014 The Large Hadron Collider (LHC) machine at CERN was designed and built primarily to find or exclude the existence of the Higgs boson, for which a large amount of data is needed by the LHC experiments.
Bailey, R.
core +1 more source