ANTISEIZURE CHARACTERISTICS OF LEADED ALUMINUM ALLOYS UNDER DRY SLIDING CONDITIONS
Aluminum-Silicon alloys, with soft lubricant metal, are considered to be one of the important tribological alloys which resist seizure. The effect of different lead percentages (1-20%Pb) that added to the modified eutectic Al-12%Si alloy on the wear ...
Akeel D. Subhi
doaj +1 more source
ANTISEIZURE CHARACTERISTICS OF LEADED ALUMINUM ALLOYS UNDER DRY SLIDING CONDITIONS
Aluminum-Silicon alloys, with soft lubricant metal, are considered to be one of the important tribological alloys which resist seizure. The effect of different lead percentages (1-20%Pb) that added to the modified eutectic Al-12%Si alloy on the wear ...
Akeel D. Subhi
doaj +1 more source
The rate of sliding and the analysis of friction on snow Part II
Using the rotation friction instrument, we tried the measurement of friction of crushed ice and found that the friction of plastics, paraffin, skiing wax may will be studied in an ordinary laboratory by the use of crushed ice instead of snow.Thus much information about the friction of snow and crushed ice was obtained, we finally used organic crystals ...
+6 more sources
Clinical consequences of changing the sliding window IMRT dose rate [PDF]
Changing pulse repetition frequency or dose rate used for IMRT treatments can alter the number of monitor units (MUs) and the time required to deliver a plan. This work was done to develop a practical picture of the magnitude of these changes. We used Varian's Eclipse Treatment Planning System to calculate the number of MUs and beam‐on times for a ...
Ghasroddashti, E. +3 more
openaire +2 more sources
In the current exploration, the specific wear rate of aluminium hybrid composites with traces amount of rare earth oxides (REOs) using pin-on-disc tribometer have been evaluated.
Vipin Kumar Sharma +2 more
doaj +1 more source
Effect of Heat Treatments on Sliding Wear Behavior of Medium Carbon Steel [PDF]
The aim of this work is to study the effect of heat treatments on the wear rate of the medium carbon steel which included normalizing and different quenching media (air, oil, salt solution at concentration %25). Quenching Include heating to a temperature
Ahlam Abdalamir Mohamed
doaj +1 more source
Predicting wear of UHMWPE: decreasing wear rate following a change in direction [PDF]
Computational tools are emerging as design tools for the development of total joint replacement with improved wear performance. The current wear models of polyethylene assume that wear is linearly proportional to sliding distance; however, it is ...
Render, Todd D. +9 more
core +1 more source
Studying the Dry Sliding Wear for Composite Material of Base (Al-4%Cu) Reinforcement by Silicon Carbide Particles [PDF]
This work is concerned with a study of dry sliding wear of Aluminum bace alloy of (Al-4%Cu) reinforcement by silicon carbide particles with different percentage (3, 6,9,12 wt %SiC).
Ahmad Ali Akbar Akbar +2 more
doaj +1 more source
Sliding Mode Control for Slosh-Free Motion using a Nonlinear Sliding Surface [PDF]
A new nonlinear switching surface is proposed for the design of a sliding mode controller for a class of mismatched uncertain systems. A control system for slosh-free motion of a partially filled liquid container is sought.
GANDHI, PS +9 more
core +1 more source
The Influence of TiO2/Si3N4 Nano-Particles on the wear Properties of Aluminium hybrid composites through stir casting process [PDF]
The Wear tests for Al-Zn alloys reinforced with TiO₂ and Si₃N₄ were conducted using the Pin-on-Disc method to estimate the wear rate under different load conditions, sliding distance, and reinforcement percentage.
Prasad T. Satya +5 more
doaj +1 more source

