Results 231 to 240 of about 10,175,253 (281)
Some of the next articles are maybe not open access.
BACTERIA, A FACTOR IN SLIP CONTROL*
Journal of the American Ceramic Society, 1949A bstract An analysis of the significance of bacteria as a factor in slip control based on actual plant experiences is given. It is shown that variations of some magnitude in the properties of casting slip can occur as a result of bacterial action.
A. L. Johnson +2 more
openaire +1 more source
Wear, 1961
Abstract Tyre wear at controlled slip, as realized by setting the wheels of a trailer at a slip angle, obeys the theoretically predicted square law dependence on the slip angle 1 if allowance is made for the effect of temperature and abrasion patterns 6,7 on the abrasion resistance of the tread compound.
K.A. Grosch, A. Schallamach
openaire +1 more source
Abstract Tyre wear at controlled slip, as realized by setting the wheels of a trailer at a slip angle, obeys the theoretically predicted square law dependence on the slip angle 1 if allowance is made for the effect of temperature and abrasion patterns 6,7 on the abrasion resistance of the tread compound.
K.A. Grosch, A. Schallamach
openaire +1 more source
Mixed Slip and Deceleration Control
2010As has been discussed in the previous chapters (see in particular Chapter 3), in braking control systems, two output variables are usually considered for regulation purposes: wheel deceleration and wheel slip. Deceleration control and slip control are mostly viewed as alternative strategies; when deceleration and slip are both used, the typical ...
Sergio M. Savaresi, Mara Tanelli
openaire +1 more source
Monopedal running control: SLIP embedding and virtual constraint controllers
2007 IEEE/RSJ International Conference on Intelligent Robots and Systems, 2007Two feedback controllers that induce stable running gaits on a three-degree-of-freedom asymmetric hopper, termed the asymmetric spring loaded inverted pendulum (ASLIP), see Fig. 1, are compared in terms of their steady-state and transient behaviors.
Ioannis Poulakakis, J. W. Grizzle
openaire +2 more sources
Control of Stick-Slip Vibrations
2006Many technical applications are subjected to friction induced vibrations. These vibrations are mostly unwanted as they generate noise, increase wear and diminish accuracy. In this paper a feedback control is introduced that is capable to suppress these oscillations. The results are validated experimentally on a squealing brake.
Marcus Neubauer +2 more
openaire +1 more source
Output feedback controller for cycle slipping in phase-controlled system
2007 46th IEEE Conference on Decision and Control, 2007This paper concerns the problem of cycle slipping for continuous phase-controlled systems with periodic nonlinearity. The number of slipped cycles is an important property in transient mode of such nonlinear systems. Based on Yakubovich-Kalman Lemma, LMI characterizations are derived for the number of slipped cycles of such systems and an efficient way
Pingli Lu +2 more
openaire +1 more source
Wheeled Inverted Pendulum Control and Slip Dynamics
2018 IEEE 14th International Conference on Control and Automation (ICCA), 2018Human transporters using a wheeled inverted pendulum structure pose significant control challenges. In addition to exhibiting instability characteristic of inverted pendulums, these machines are also subject to a large range of environmental disturbances, and the time-varying inertia of a human rider.
Khalid L. Sorensen, William Singhose
openaire +2 more sources
Reachability-based control for the active SLIP model
The International Journal of Robotics Research, 2015One of the key topics in robotics is legged locomotion, taking inspiration from walking and bouncing gaits of bipeds and quadrupeds. A fundamental tool for analyzing running and hopping is the spring loaded inverted pendulum (SLIP), thanks to its simplicity but also effectiveness in modeling bouncing gaits. Being completely passive, the SLIP model does
Giulia Piovan, Katie Byl
openaire +1 more source
Vibration Control to Avoid Stick-Slip Motion
Journal of Vibration and Control, 2004Friction-induced self-sustained oscillations result in a very robust limit cycle that characterizes stick-slip motion. This type of motion should be avoided under any circumstances because it creates noise, wear, and damage. In this paper we show, by simple models, how stick-slip motion can be avoided. Effective methods are: (i) appropriate increase of
Popp, Karl, Rudolph, Martin
openaire +1 more source
CONTROL OF PLASTICITIES OF CERAMIC SLIPS*
Journal of the American Ceramic Society, 1932ABSTRACT In terms of a given apparatus of suitable standard dimensions the plastic flow characteristics of various ceramic slips may be measured and recorded. Each slip has its characteristic plasticity which is a highly important factor in connection with its successful use in the specific process for which it is intended and this ...
openaire +1 more source

