Results 51 to 60 of about 53,637 (257)
Science and Engineering of Composite Materials, 2017 Carbon nanotubes (CNTs) were successfully prepared using chemical vapor deposition method on nickel-coated silicon substrates. The CNTs were then modified to obtain functionalized ends.
Ma Weiwei, Zhou Zhiping, Li Ping
doaj +1 more source
Geophysical Research Letters, 2022 We conducted fluid injection experiments on cylindrical low‐permeability granite samples with a critically stressed sawcut fault at local injection rates of 0.2 and 0.8 mL/min and confining pressures of 31 and 61 MPa.
Yinlin Ji +4 more
doaj +1 more source
Zhongguo Jianchuan Yanjiu, 2022 ObjectivesFlow separation increases the drag and noise of underwater vehicles, and influences the controllability of their control surfaces. Therefore, the influence of slip caused by superhydrophobic surfaces on drag reduction and flow separation is ...
Wei CHEN, Wenjun LENG, Peng HE, Lei WANG
doaj +1 more source
A Workflow to Accelerate Microstructure‐Sensitive Fatigue Life Predictions
Advanced Engineering Materials, EarlyView.This study introduces a workflow to accelerate predictions of microstructure‐sensitive fatigue life. Results from frameworks with varying levels of simplification are benchmarked against published reference results. The analysis reveals a trade‐off between accuracy and model complexity, offering researchers a practical guide for selecting the optimal ...
Luca Loiodice +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.A flexure‐based variable stiffness structure is developed by integrating phase‐change modulation and adhesive interfacial locking of gallium. The design enables a wide stiffness variability, transitioning from soft, flexible behavior to rigid, load‐supporting performance.
Sungjin Kim +2 more
wiley +1 more source
Translucency and negative temperature-dependence for the slip length of water on graphene
Nanoscale, 2022 The translucency and temperature dependence of slip length for water on graphene is experimentally found. Adhesion energy and the comprehensive effect of density, viscosity, dielectric constant, and force relaxation time are key factors.
Han Li, Zhi Xu, Chen Ma, Ming Ma
openaire +3 more sources
Advances in Polymer Technology, 2019 In this paper, a slip length model is proposed to analyze the enhanced flow based on the Hagen–Poiseuille equation. The model considers the multimechanisms including wall-water molecular interactions, pore dimensions, fractal roughness, and temperature ...
Lei Li +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Simulation of the Slip Velocity Effect in an AC Electrothermal Micropump
Micromachines, 2020 The principal aim of this study was to analyze the effect of slip velocity at the microchannel wall on an alternating current electrothermal (ACET) flow micropump fitted with several pairs of electrodes. Using the finite element method (FEM), the coupled
Fraj Echouchene +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Trace additions of Sn and Sr combined with a two‐step aging treatment are shown to enhance the microstructure and performance of Al–Zr–Sc conductor alloys. Strength and electrical conductivity increase concurrently through accelerated precipitation of fine Al3(Sc, Zr) precipitates and improved dislocation resistance, offering a cost‐effective pathway ...
Quan Shao +3 more
wiley +1 more source