Results 51 to 60 of about 577,675 (243)

Slurry Erosion – Design of Test Devices [PDF]

Advances in Materials Science, 2017
Abstract Degradation of material caused by impacts of a solid particle (erodent) suspended in a liquid is called slurry erosion and is a major problem in the hydropower and maritime industry. Slurry erosion depends on many factors, e.g.
M. H. Buszko, A. K. Krella
openaire   +1 more source

Comparative Analysis on Reinforcement of Potential Additives in WOKA Cermet HVOF Coating Subjected to Slurry Erosion in Ash Conditions [PDF]

Iranian Journal of Materials Science and Engineering, 2022
In this paper, an investigation was carried out to test the suitability of potential additive materials in WOKA 3533 (WC-10Co4Cr) cermet HVOF coating subjected to slurry erosion in ash conditions.
Jashanpreet Singh, Rana Gill, Satish Kumar, S.K. Mohapatra   +3 more
doaj  

Improvement of Erosion-Corrosion Behavior of AISI 420 Stainless Steel by Ion-Assisted Deposition ZrN Coatings

Metals, 2021
In this paper, a pragmatic technique has been developed to evaluate the erosion-corrosion behavior of three kinds of ZrN coatings (i.e., monolayer, multilayer, and gradient layers) which were deposited on AISI 420 martensitic stainless steel using an ion-
Yuntao Xi, Lin Wan, Jungang Hou, Zhiyong Wang, Lei Wang, Daoyong Yang, Daoxin Liu, Shubin Lei   +7 more
doaj   +1 more source

Slurry erosion behavior of hydro-turbine steel treated cryogenically at different soaking periods [PDF]

, 2021
Munish Kumar, Hazoor Singh Sidhu, Buta Singh Sidhu   +2 more
openalex   +1 more source

Prediction of Slurry Erosion–Corrosion in SLM-Produced Ti-6Al-4V Using ANFIS Modeling: Influence of Impact Angles and Erodent Mass

Machines
Understanding erosion–corrosion mechanisms in selective laser-melted (SLM) Ti-6Al-4V is essential for optimizing component durability in demanding sectors such as oil and gas, hydropower, and offshore engineering, where slurry-induced degradation ...
Saleh Ahmed Aldahash, Ibrahem Maher, Yasser Abdelrhman, Osama Abdelaal   +3 more
doaj   +1 more source

CONSTRUCTION OF SLURRY JET EROSION TESTER AND THE EFFECT OF PARTICLE SIZE ON SLURRY EROSION

Mağallaẗ Al-kūfaẗ Al-handasiyyaẗ, 2018
A Jet erosion tester is designed and used to study the relative erosion behavior of high chromium white cast iron (ASTM 532A) at specific concentration of silica sand as an abrasive material, 45° impact angle and two size of abrasive particles.
Israa F. Yousif, Ali H. Ataiwi
doaj   +1 more source

Failure analysis of additively manufactured PLA with different morphological arrangements in erosive flow

Journal of Materials Research and Technology
This study investigated the impact of water-sand slurry on Polylactic Acid (PLA) in Fused Deposition Modeling (FDM), exploring different morphologies and variables using Taguchi design.
Bilal Khan, Rehan Khan, Abdel-Hamid I. Mourad, Michał Wieczorowski, Asiful H. Seikh, Ibrahim A. Alnaser   +5 more
doaj   +1 more source

Runoff- and erosion-driven transport of cattle slurry: linking molecular tracers to hydrological processes [PDF]

Biogeosciences, 2016
The addition of cattle slurry to agricultural land is a widespread practise, but if not correctly managed it can pose a contamination risk to aquatic ecosystems.
C. E. M. Lloyd, K. Michaelides, D. R. Chadwick, J. A. J. Dungait, R. P. Evershed   +4 more
doaj   +1 more source

Erosion wear performance of HVOF sprayed WC-10Co-4Cr + 2% TiO2 coating on SS-409 using slurry jet erosion tester

Results in Surfaces and Interfaces
Erosion is a phenomenon and is the primary cause of failure in numerous slurry transportation equipment such as pump impellers, pipeline fittings, etc.
Asisha Ranjan Pradhan, Satish Kumar, Chandan Gupta, Swaroop Kumar Mandal   +3 more
doaj   +1 more source

A numerical study of the slurry erosion in 90° horizontal elbows

Journal of Pipeline Science and Engineering
The slurry erosion processes of horizontal elbows are investigated numerically using an Eulerian-Lagrangian method coupled with particle rebound and erosion model. First, a mechanical model for the internal multiphase flow involving slurry erosion in the
Yijie Wang, Xin Wang, Peijuan Shang, Zhenkang Xu, Qiyu Huang   +4 more
doaj   +1 more source