Results 61 to 70 of about 13,991 (262)
Structural and Luminescence Properties of SnO2 Nanostructures Via Porcine Gelatin-Assisted Synthesis
Porous nanostructured SnO2 with a sheet-like morphology was synthesized through a simple green substrate-free gelatin-assisted calcination process using Tin tetracholoride pentahydrate as the SnO2 precursor and porcine gelatin as the template ...
Arian Heidar Alaghband +3 more
doaj
Low‐Temperature Gold Deposition Improves CdTe Back Contacts
Cd(Se,Te) samples are cooled during the evaporation of Au back contacts to thermally quench CdTe degradation. Reduced temperature during Au evaporation boosts PV efficiency, open‐circuit voltage, and fill factor. XPS associates these improvements with less chemical perturbation of the CdTe surface during metallization.
Christopher P. Muzzillo +5 more
wiley +1 more source
The performance of the electron transport layer in perovskite solar cells is a key factor in achieving stable device efficiency and a primary consideration for flexible devices.
ZHU Yinbin +5 more
doaj +1 more source
A lead‐free and Cd‐free RbSn₀.5Ge₀.5I3 perovskite solar cell is optimized through In2Se3/CuI charge‐transport engineering using SCAPS‐1D. Spike‐type band alignment suppresses interfacial recombination, enhances charge extraction, and achieves a power conversion efficiency of 26.01%, providing an effective strategy for high‐performance and ...
Md. Al Amin +5 more
wiley +1 more source
SnO₂ AS A SENSITIVE LAYER IN GAS SENSORS FOR MEDICAL AND ENVIRONMENTAL MONITORING
This study presents an investigation of the sol–gel synthesis of tin(IV) oxide powders intended for gas-sensor applications. The precipitates obtained via the sol–gel route were calcined at 250, 400, and 550 °C and characterized by X-ray diffraction and ...
Oleksii KLIMENKOV, Tetiana DONTSOVA
doaj +1 more source
A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang +8 more
wiley +1 more source
Defect‐Engineered ZnO Nanowire Arrays for Flexible Room‐Temperature Hydrogen Sensors
Fabrication process of patterned ZnO nucleation sites on a flexible polyimide (PI) substrate. Top/tilted‐view SEM images of ordered ZnO nanoflower arrays confined within patterned circular regions. AFM topography map with height data revealing a disk‐array structure, where the patterned regions (marked by a red dot circle) are elevated by ∼2 µm ...
Jun‐Ting Wang +7 more
wiley +1 more source
Transparent thin film transistors of polycrystalline SnO2−x and epitaxial SnO2−x
We report on transparent thin film field effect transistors (TFTs) based on polycrystalline SnO2−x and epitaxial SnO2−x. Polycrystalline SnO2−x TFTs of the top and the bottom gate geometries exhibited high mobility values of 145.7 cm2/V s and 160.0 cm2/V
Yeaju Jang, Hahoon Lee, Kookrin Char
doaj +1 more source
Laser‐induced graphene (LIG) provides a scalable, laser‐direct‐written route to porous graphene architecture with tunable chemistry and defect density. Through heterojunction engineering, catalytic functionalization, and intrinsic self‐heating, LIG achieves highly sensitive and selective detection of NOX, NH3, H2, and humidity, supporting next ...
Md Abu Sayeed Biswas +6 more
wiley +1 more source
Neuromorphic Near‐Sensor and In‐Sensor Computing Enabled by Next‐Generation Material‐Based Sensors
This Review presents a structural framework that classifies neuromorphic sensing into near‐sensor and in‐sensor architectures, clarifying physical coupling between sensing and computation. The framework connects neural and synaptic device functions with recent advances in optical, mechanical, and chemical sensing, compares energy consumption and ...
Su Yeon Jung +7 more
wiley +1 more source

