Results 181 to 190 of about 884 (213)

Single Cu Atom Sites on Co3O4 Activate Interfacial Oxygen for Enhanced Reactivity and Selective Gas Sensing at Low Temperature

open access: yesSmall, EarlyView.
Atomically dispersed Cu sites on Co3O4 nanoparticles establish well‐defined Cu–O–Co interfacial linkages that promote lattice oxygen activation at markedly reduced temperatures. This structural and electronic modulation yields over twenty‐fold higher low‐temperature formaldehyde sensing responses than CuO nanoparticle analogues, enabling selective and ...
Hamin Shin   +7 more
wiley   +1 more source

A Hybrid Solid‐State Battery with a Panoramic‐Scale Stack of Bulk Electrodes and a Thin‐Film Electrolyte

open access: yesSmall, EarlyView.
A hybrid all‐solid‐state battery (ASSB) is implemented by integrating a thin‐film electrolyte on a bulk anode, and a thick cathode sheet. A densified anode substrate with suppressed porosity is prepared by cold pressing. Thin‐film electrolyte is fabricated onto the bulk substrate via co‐sputtering and infrared‐based rapid annealing.
Hyeseong Jeong   +7 more
wiley   +1 more source

Toward Efficient and Reliable Chemical Upgrading Using Solid Oxide Electrochemical Reactors, Mechanisms, Challenges, and Design Principles

open access: yesSmall, EarlyView.
Solid oxide electrochemical reactors (SOERs) offer a compelling pathway for coupling renewable electricity with chemical manufacturing, but their real application is still limited by low efficiency and instability. This review systematically summarizes SOER reaction mechanisms, performance‐limiting factors, and recent progress toward high‐efficiency ...
Nai Shi   +3 more
wiley   +1 more source

Influence of Viscous Dissipation on Wear Behavior and Hardness Evolution of Tool Steels in Glass‐Fiber‐Reinforced Polymer Processing

open access: yessteel research international, EarlyView.
Tool steels tested under injection molding conditions with glass‐fiber‐reinforced polymers, revealing how viscous dissipation drives hardness loss, even in PM grades. A sharp rise in wear with increasing injection volume rate and thermomechanical load uncovers striking material differences.
David Zidar   +3 more
wiley   +1 more source

Effect of Postweld Heat Treatment on Laser‐Welded Duplex Stainless Steel: Crystallographic Patterns and Fatigue Behavior

open access: yessteel research international, EarlyView.
Laser welding of duplex stainless steel disrupts phase balance, promotes nitride precipitation, and reduces fatigue resistance. Postweld heat treatment restores austenite and dissolves nitrides, but the resulting crystallography and phase morphology still impair fatigue performance.
Aparecida Silva Magalhães   +6 more
wiley   +1 more source

Global Fluoride Toxicology Landscape: Bibliometric Approaches and Scientific Mapping

open access: yesEnvironmental Toxicology, EarlyView.
ABSTRACT This study analyzed research trends in the 100 most‐cited articles on fluoride toxicology, a topic widely debated due to the toxic effects associated with levels deemed safe for human exposure. A bibliometric analysis was conducted using the Web of Science‐Core Collection, extracting data such as citation count, authors, keywords, journal ...
Maria Karolina Martins Ferreira   +8 more
wiley   +1 more source

Beyond Removal Efficiency: Environmental Risk Assessment of Tartrazine Degradation via ZnO and TiO2 Nanoparticles in Mussels

open access: yesEnvironmental Toxicology, EarlyView.
ABSTRACT Tartrazine (TZ) is a widely used synthetic azo dye with high aqueous stability, resulting in persistence in wastewater. Photoreactive nanomaterials, principally zinc oxide (ZnO) and titanium dioxide (TiO2) nanoparticles (NPs), are frequently employed for dye removal under light‐exposed conditions; nevertheless, their ecotoxicological ...
İrem Can   +3 more
wiley   +1 more source

Quantitative micro‐XRF combined with X‐ray imaging reveals correlations between Zn concentration and dentin tubule porosity across entire teeth

open access: yesVIEW, EarlyView.
The combination of calibrated micro‐CT and quantitative micro‐XRF measurement facilitates the correlation of density and composition in the 3D macro‐structure of teeth. Zn concentration in dentin increases by a factor of 10 toward the pulp. Incidentally, the overall density decreases, showing an association between Zn and the dentin tissue porosity ...
Ioanna Mantouvalou   +11 more
wiley   +1 more source

Super-enhancer-drivenCACNA2D2is an EWSR1::WT1 signature gene encoding a diagnostic marker for desmoplastic small round cell tumor (DSRCT)

open access: yes
Geyer FH   +31 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy