Results 51 to 60 of about 108,318 (218)

Positive‐Tone Nanolithography of Antimony Trisulfide with Femtosecond Laser Wet‐Etching

Advanced Functional Materials, EarlyView.
A butyldithiocarbamic acid (BDCA) etchant is used to fabricate various micro‐ and nanoscale structures on amorphous antimony trisulfide (a‐Sb2S3) thin film via femtosecond laser etching. Numerical analysis and experimental results elucidate the patterning mechanism on gold (reflective) and quartz (transmissive) substrates.
Abhrodeep Dey, Uwe Hübner, Albane Benardais, Xiaofei Wu, Andrea Dellith, Jan Dellith, Torsten Wieduwilt, Henrik Schneidewind, Markus A Schmidt, Virginie Nazabal, Volker Deckert, Jer‐Shing Huang, Wei Wang   +12 more
wiley   +1 more source

MOFs and COFs in Electronics: Bridging the Gap between Intrinsic Properties and Measured Performance

Advanced Functional Materials, EarlyView.
Metal‐organic frameworks (MOFs) and covalent organic frameworks (COFs) hold promise for advanced electronics. However, discrepancies in reported electrical conductivities highlight the importance of measurement methodologies. This review explores intrinsic charge transport mechanisms and extrinsic factors influencing performance, and critically ...
Jonas F. Pöhls, R. Thomas Weitz
wiley   +1 more source

Three‐dimensional Antimony Sulfide Based Flat Optics

Advanced Functional Materials, EarlyView.
This work presents the development of a grayscale electron beam lithography (g‐EBL) method for fabricating antimony trisulfide (Sb2S3) nanostructures with customizable 3D profiles. The refractive index of g‐EBL patterned Sb2S3 is determined based on the synergy of genetic algorithm and transfer matrix method.
Wei Wang, Uwe Hübner, Anne Gärtner, Tao Chen, Joseph Köbel, Franka Jahn, Daniel Repp, Abhrodeep Dey, Henrik Schneidwind, Andrea Dellith, Jan Dellith, Torsten Wieduwilt, Matthias Zeisberger, Tanveer Ahmed Shaik, Astrid Bingel, Markus A. Schmidt, Jer‐Shing Huang, Ulf Peschel, Volker Deckert   +18 more
wiley   +1 more source

Determination Of Power Loss In Fe-Based Soft Magnetic Composites

Archives of Metallurgy and Materials, 2015
The magnetic properties of Fe-based composite materials with different particle sizes were investigated. The results of energy loss density were obtained from measurements of the static (DC) hysteresis cycles ranging from 0,2 to 1,4 T.
Jankowski B., Kapelski D., Ślusarek B., Szczygłowski J.   +3 more
doaj   +1 more source

PEDOT‐Based Eutectogel Electrode Arrays for Enhanced High‐Resolution Electrogastrography: Fabrication, Stability, and Wearable Performance

Advanced Functional Materials, EarlyView.
Here, we present a high‐density PEDOT eutectogel electrode array for enhanced body surface gastric mapping. Silver electrodes are blade‐coated onto flexible substrates, followed by electrogelation of PEDOT:PSS and the deposition of a PEDOT:LS eutectogel.
Christopher Slaughter, Luke Gatecliff, Xudong Tao, Ruben Ruiz‐Mateos Serrano, Amy T. Jin, Matias L. Picchio, Daniele Mantione, Antonio Dominguez‐Alfaro, George G. Malliaras   +8 more
wiley   +1 more source

Tuning the Electronic Structure and Spin State of Fe─N─C Catalysts Using an Axial Oxygen Ligand and Fe Clusters for High‐Efficiency Rechargeable Zinc–Air Batteries

Advanced Functional Materials, EarlyView.
A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou, Yu Mao, Mengyao Chang, Ziyun Wang, Wenke Xie, Cuizhu Ye, Shanghai Wei, Lars Thomsen, Geoffrey I. N. Waterhouse   +8 more
wiley   +1 more source

Analysis of magnetostriction of oriented silicon steel under motor magnetic field

AIP Advances
The performance requirements of motors are gradually increasing, and anisotropic soft magnetic materials have been applied in motors to improve performance, The magnetostriction of anisotropic soft magnetic materials is one of the main contributors in ...
Yuxiao Li, Zhiye Li, Xusheng Lu, Guangshuai Shao, Jiaxin Liu, Ruilin Pei   +5 more
doaj   +1 more source

Magnetic Flux Concentration Technology Based on Soft Magnets and Superconductors

Crystals
High-sensitivity magnetic sensors are fundamental components in fields such as biomedicine and non-destructive testing. Flux concentration technology enhances the sensitivity of magnetic sensors by amplifying the magnetic field to be measured, making it ...
Yue Wu, Liye Xiao, Siyuan Han, Jiamin Chen   +3 more
doaj   +1 more source

Multilayer Soft Photonic Arrays Inspired by Cephalopod Skin for High‐Density, Independent, and Multimodal Actuation

Advanced Functional Materials, EarlyView.
A vertically stacked, DEA‐driven photonic array inspired by cephalopod skin, featuring highly crystalline colloidal crystal gels with vivid color, low FWHM and scalability is presented. The multilayer design removes lateral pixel interference, achieving near‐100% fill factor with fully independent RGB actuation.
Maga Kim, Imbo Kong, Do Yoon Kim, Jaeyoung Choi, Seong‐Yu Choi, Yun Hyeok Lee, Sihwan Lee, Byung Ik Park, Gimin Sung, In‐Suk Choi, Wook Sung Kim, Jeong‐Yun Sun   +11 more
wiley   +1 more source

Research progress on preparation techniques of soft magnetic composites for molded inductors

Gongneng cailiao yu qijian xuebao
The ongoing trend toward miniaturization, high-frequency operation, and integration of inductive components, has increased the demand for enhanced performance of soft magnetic composite materials used in integrated molded inductors.
Mengyuan TIAN, Yunfei WU, Zhanyun WANG, Xiaoyong ZHU, Jiewu CUI, Yong ZHANG, Yucheng WU   +6 more
doaj   +1 more source