Results 51 to 60 of about 1,203,684 (294)
With further population of gallium nitride (GaN) devices, traditional boost topology has an opportunity to obtain a higher power density with a higher switching frequency.
Yifeng Wang +3 more
doaj +1 more source
New DC/DC High Step Up Isolated Converter with ZVS [PDF]
In this paper we presents a soft switch sepic, flyback converter. At first the converter have hard switching in main switch and completely analysis then added auxiliary circuit for soft switching Auxiliary circuit in the converter is not only soft ...
Ehsan Movahedi +2 more
doaj
Application of a Novel ARCP Circuit in UPS
In order to reduce the loss of the power switching device and improve the efficiency of the UP system,the ARCP soft switching technology can be used.
MA Jun-jie +3 more
doaj +1 more source
Improved Interleaved Buck Converter with High-Step Down Conversion Ratio and Soft-Switching
This article proposes a new interleaved buck converter with a high step-down conversion ratio and soft-switching. The soft-switching conditions for the main IGBTs are achieved with the aid of a simple auxiliary circuit, which comprises a resonant ...
Pavel Drabek +7 more
core +1 more source
Ferroelectric nanoclusters create local internal fields in a normally non‐switchable polar film because of polarization mismatch at their interfaces. That field opposes polarization in the regions with larger polarization and reinforces polarization in the regions with smaller polarization.
Anna N. Morozovska +5 more
wiley +1 more source
Monolithic UV‐ozone oxidation of Ta forms an ultrathin Ta2O5/TaOx bilayer enabling resistive switching with a vertical defect gradient. A stoichiometric surface layer over an oxygen‐deficient sublayer promotes localized filament nucleation near the top interface, enabling low‐voltage operation, and reduced cycle‐to‐cycle variability.
Seunghoon Yang +11 more
wiley +1 more source
Strong Lead‐Free Bioinspired Piezoceramics for Durable Energy Transducers
We fabricated brick‐and‐mortar lead‐free piezoceramics with Bi0.5Na0.5TiO3 monocrystal platelets as bricks and amorphous silica as mortar. The alignment of the bricks and the presence of the amorphous silica led to anisotropic residual stresses. These residual stresses increase the samples toughness, strength and durability while the brick alignment ...
Ruxue Yang +12 more
wiley +1 more source
A single‐step laser annealing strategy is presented for dual‐gate a‐IGZO TFTs. The steep thermal gradient induces graded oxygen doping in the channel and simultaneous WOx removal at the contacts, enabling concurrent interface and contact engineering.
Sihyeon Kwon +9 more
wiley +1 more source
: This article presents the performance evaluation of an isolated dual active half-bridge (DAHB) converter with discrete SiC MOSFET devices. The impact of a resonant network on the SiC MOSFET DAHB under two different modes is investigated.
Veera Venkata Subrahmanya Kumar Bhajana +3 more
doaj +1 more source
Simulation and Implementation a Non-Isolated Buck Converter at ZCS Condition [PDF]
A new soft-switching resonant inverting-buck converter with high efficiency is presented. The proposed converter steps down and inverts the input voltage.
Nahid Hematian, Masoud Jabari
doaj

