Results 1 to 10 of about 4,566,606 (288)
Use and Influence of Tire Rubber Waste Powder in Bitumen Product [PDF]
Journal of Engineering, Project, and Production Management, 2021 The waste generation from old rubber tires has been increasing and causing environmental degradation with the escalation of vehicles number especially in the cities.
Leopold Mbereyaho +3 more
doaj +1 more source
Marshall stability of porous asphalt mixture incorporating kenaf fiber [PDF]
Archives of Civil Engineering, 2022 Porous asphalt mixture (PA), known as open-graded surfaces over a stone bed underneath, allows water to go through. These factors can affect the porous asphalt mixture adhesive strength.
Nur Ezreen Jasni +7 more
doaj +1 more source
Physical/Rheological Characteristics of Bitumen Modified by SBS, ZnO, TiO2 and EVA Precursors [PDF]
Journal of Chemical and Petroleum Engineering, 2021 Owing to climate conditions, heavy traffic loads, and increasing axial loads, conventional bitumen/asphalt should be modified. Bituminous materials are also vulnerable to aging during construction and service time of pavement, which will seriously affect
Fariba Karimian +1 more
doaj +2 more sources
矿业科学学报, 2021 The Xinjiang water conveyance tunnel is a shallow buried mudstone stratum. After the water absorption, the strength of the surrounding rock softens and large deformation occurs.
Zhang Yong +5 more
doaj +1 more source
C, 2020 Carbon/carbon (C/C) composites are conventionally manufactured by liquid-phase impregnation (LPI), in which the binder pitches and phenolic resins are impregnated into the composites, and by chemical vapor infiltration (CVI).
Jae-Yeon Yang +4 more
doaj +1 more source
Cellulose Microfibril and Micronized Rubber Modified Asphalt Binder
Fibers, 2021 Cellulose microfibrils (CMFs) and micronized rubber powder (MRP) can be derived from low or negative-cost agricultural/industrial waste streams and offer environment-friendly and cost-effective pathways to develop engineering products.
Ang Li +6 more
doaj +1 more source
Effect of Polymer on Bitumen Properties and its Performance Grade [PDF]
علوم و تکنولوژی پلیمر, 2008 With respect to the physical and mechanical limited qualities of bitumen, it benefits from certain specificability in application and its life service.
H. Ziari, S.M. Abtahi, A. Goli
doaj +1 more source
Energies, 2022 The use of hydrocracked and straight-run vacuum residues in the production of road pavement bitumen requires a good understanding of how the viscosity and softening point can be modeled and controlled.
Dicho Stratiev +14 more
doaj +1 more source
ASSESSMENT OF THE PROPERTIES OF ASPHALT MODIFIED WITH USED TIRES [PDF]
Civil Engineering Journal, 2017 This study investigates the properties of asphalt mix modified with ground tire. The ground tire was introduced into the asphalt in a melted form at varying percentages of 2%, 4%, 6%, 8% and 10% by weight of the asphalt.
Olufikayo Aderinlewo
doaj +1 more source
Blending of Hydrocarbon and Rosin Ester-basedResins to Study its Effect on the Physical andMechanical Properties of Thermoplastic Road Markings [PDF]
علوم و تکنولوژی پلیمر, 2009 In this study, the effect of hydrocarbon and rosin ester resins combination on the physical and mechanical properties of thermoplastic road markings were evaluated.
S.M. Mirabedini +4 more
doaj +1 more source